Whatever heat sink you use, buy good thermal paste, when you pick a heat sink, pick a bigger one, blow enough air across it until you work out the kinks. And most importantly figuring on paper and designing will get you further than trial and error
🙃You have to learn a lot more about controling mosfets, protecting them, snubbers,.... Main problem with tv transformer is that it have builtin rectifier so you loaded it with arcing only in half of cycle so DC field will buildup in core efectively losing inductance and results in level shift in that input capacitor totem and overcurent of mosfets and boom,... Overcurrent protection, correct driving of gates and snubber is the way. Check this page and learn. danyk.cz/index_en.html
these will be for a full bridge inverter. I have made one already, but I do not like it. The dynalyzer doesn't need any work, so it's just sitting for now.
Im glad you left the noise in on the time lapse. Kinda sounds sarcastic but it’s not I find it really eery and creepy when it’s silent. Anyway I have never touched a super cap (which is what I’m assuming these are from the size) but im sure your doing a great job.
@friendlynerd599 id put some music but all the no copywrite ones don't sound good. These aren't considered super caps I think, since there capacitance is quite small. But yes they are quite heavy.
In this I use a 9 volt battery and step it down to 6 or 7 volts, then that is connected to the bike along with a capacitor. If you have the old battery, try adding new acid to it, that worked for me. There is one on Amazon that isn't an exact replacement but fits in the compartment and is able to start the bike.
This is a Dynalyzer II. We now manufacture the Dynalyzer IV. It is used to measure the output of X-ray generators. The large board is called the receiver board. The smaller one is the oscillator board as it provides drive to the isolation transformer inside the tank. The max voltage for either side of the tank is +80kV anode and -80kV cathode.
thank you, it says Dynalyzer III on the board, though. I did not know there was an isolation transformer. I wondered how that worked. Would you happen to know the max current it can handle? (From transformer anode to tube anode, or transformer cathode to tube cathode)
it came from a bug zapper, dats it, but if you want the higher power stuff microwaves are good sources for transformers, though i dont recommend it because its very lethal and goes to 2kv ac
I have 120 DC , created with three transformers, then rectified and filtered, then put in series. that is turned into AC and then goes into the transformer.
Something to consider about ceramic/ferrite transformer cores is periability and resonant frequency of the cores saturation at certain frequencies. Flyback transformer cores from old monitors or TV's usually have around 14khz frequency resonance so tune your driver frequency while watching the output to peak when resonance is achieved. This will help you get max power out of your driver circuit.
I keep this in mind, but remember that resonant frequency changes when you put a load on the secondary, so you need something that changes the frequency on the fly, like a zvs. Resonant frequency changes depending on a few things like the #of turns and capacitors if you have any if the circuit. I will build a zvs when I buy some high frequency capacitors.
@@ArcEng1ne a long time ago im the first 1 to figure it out its a secret i keept a long time, just don't spreed it to the block story developer or admins/ wiki /discord/other pages, if they hears about ir so wil it be nerfed or patched. But sens i never told Annyone before so is it not discovers by others yet and as such its stil good amount. And with ted dinosaur daily quest and the daily Skelton quest, I get around 15 to 20 diamonds, if I lucky fishing up diamonds often enough I get like 20 to 35 diamonds, So once a day I get good amount, And sens diamond also save so can i also make new character Lvl it up fast, get some diamond and do easy Quest and get diamond again, and then delete the newest save but keep the old one i come longest in due to i can fish in it. So i get diamonds even faster that way, no need to change the files Ted and skeleton daily Quest both give 5 diamonds each day real life So thats 10 diamonds with diamond from clown fish is 15 or 18 Sharks 16 to 20 toggether, If they are separated so wont shark kill the clown fish, Use soul catcher to make spawners and then ou have infinite diamond farm truh fishing, i do recommend to have allot of baits tho shark is bit difficult to catch PS when it become a thing it's always been a thing it's just no players don't take time in fishing, so the admin/Moderator/developer Don't know about it due to I never told anyone about it before and I do not plan to tell them about it either. I still remember back in the days you could get like 2 to 5 diamond from mining but when that news got out so was diamond drop from mining seriously nerfed now you can get only 1 to 2 and drop chance from mining it very rare, so don't tell them about the fishing.... Let's us keep this secret 😎
SO GLAD I CAME ACROSS THE VID still works in 2024 ios newer version just takes a sec to get through glitch going new sub i just got back into block story after YEARS since i was a fcking little kid my god i still remember my cuzzo introducing me to steven universe and this game in one night
