udaya Tech Channel This channel is all about new projects, New technology, and some of our diy and some of daily life hacks too 1. We make some diy boat, Diy cars, diy plane, and lots more about rc. 2. We also make some intersting school project for exibition and for science fair l love science fair and do love to visit and create some projects When i was small my dream were to crete new ideas
please please please subscribe my channel And support me. For more interesting videos
Output pin 3 of IC 555 of first input IC 555 has not been used. +and - polarity of electrolytic condenser 100 mfd has not been shown on the circuit Anil Kumar Goel
HELLO...GREAT VIDEO!! I wanted to share a tip with you that I learned after MANY YEARS...You should NEVER wind electrical tape while it is stretched in the least. Over time it 'UN-stretches!! Instead, pull some from the roll, then let it 'relax' a few seconds, and then PRESS it around. --dALE
Very interesting circuit.sir here is I have some enquiry, can I use MJE 13005 in place of J13009. If yes then there be any changes in circuit. Pl. sir help me. Awaiting for your answer. Thanking you.
Thank you for the video, it's just what I was looking for! Could you please advise me what component values to change, to get frequency variation between 20 and 27 kHz? Also I'd like to attach a mosfet to the output to commutate 12V. Could you help me with these two tasks, please? Thank you in advance!
Great video to show how to rewire a three pole motor simply. One question. How does the gauge of the wire affect the speed of the motor? e.g. 20 gauge wire gives x rpm and 26 gauge gives y rpm for the same voltages.