Dear Sir, i have configured, interface 1/2 layer 3 interface for internal network and configured interface 1/3 layer 2 interface for security camera. Interface 1/2 and Interface 1/3 is connected with switch in trunk mode and i have configure svi for interface 1/3. Now, i can use internet and i can communicate with Interface 1/2 from Interface 1/3 but i can't communicate from interface 1/2 to 1/3 interface. i have made bi-directional security policy as well. where i have allowed all any. But still i can't communicate from interface 1/2 to interface 1/3 network. Please suggest the solution.
Hi..It's hard to tell from few info but I am guessing you have created L2 Vlan on Switch and device behind the L2 Vlan using Gateway IP configured on firewall interface 1/2, but it's failing to connect back to devices behind 1/3 interface. You may need to create a NAT (PAT) using source from subnet behind L2 Vlan and PAT with 1/3 interface IP. On firewall there could be several reasons what you can find in the logs Thanks
I'm new to palo alto and this video helps me much. But if you could utilize the environment sound that would be better for the viewer. Thank you anyway
Hi Shafi - in my experience most interviewer will ask you the theory part, but I have covered most topics might surely help you during interview what interviewer is asking in regards to specific topic. All the best for the interview!
@@bharatrajwanshi4868 thanks bhai 🙂 There is one request it would be very helpful if i would get any reference for freshers role of you could refer me to any role in networking domain for technical support or network support it would be very helpful I'm looking for job from little while I'm not getting any job .
I work From home and when i Connect my global protect internet get discconect and global Connect dora Not finish conectiong i need to fix this because all my client systems will no open without the global protect
in some cases problem could be with GP Config on firewall, if you are doing all route (0.0.0.0/0) points via GP Gateway you need to check security policy if internet might access block for GP users or zone, also check with NAT for GP Subnet. if doing split tunnel should go out via local home internet. Thanks
Brother please note this point as many students struggling with content id security policy 1.anti virus 2.anti spyware 3.vulnerability protection 4.URL filtering 5.file blocking 6.data filtering 7.wildfire analysis 8.security profile group These terms are so confusing Sometimes its like samething.. Could you please take depth & good lectures with each terms practically ?
