That’s genius thanks so much!!

Doesn’t have to be a 2-pole breaker. Can be two adjacent single poles.

Almost bought 2/0 for a starting cable😂 luxky i didnt

Thank you for a fast, straightforward, no nonsense answer. Again thank you. Much appreciated 🙏 ❤❤❤

slick tip

Maddison bars

Thank you. Help out Tremendously. First person who explain well without confusing you!

made no sense

can someone please share information about the dimensions of the spring nut. whats the groove/teeth dimensions? does the spring nut press only against the lip of the unistrut or also against the top flange of the unistrut?

Yea but when you got 3/8” conduit, shit dont go smaller… hell I’m lucky to get 3/8 parts at the warehouse.. i’ll just make em live and cut until i see sparks..

So simple, yet brilliant, thank you

Thanks for the info, i appreciate it.

Thanks COOP ...

thanks, your brief explanation just helps a lot

Can you use plastic snap in connectors (like Arlington Black Button NM96) with reducing washers, or do they require something with a locking nut that can tighten down on the reducing washers?

The reducing washer didn’t work as it left no thread left to screw on the lampshade retaining ring

"Bring me a number 2" *comes back with poop

Agreed 1000%!! It's ultimately up to us to make safety number one! Ultimately, in the end, we're the ones that are responsible for the outcome of a project. Therefore, the liability also rest on us. Well-stated!

With the correct glue at that lol

Gay

PVC of the smaller sizes is impossible to push all the way together without melting it with solvent. The fittings on the smaller sizes have fittings that taper inwards.

Stapling wire to close with staples Zip tying wires a no no No more then two 14/2 wires with reg staple Nail plates etc etc

6’ under… a bit much but good point overall

Thanks. I have to run 50 feet through and hope that tip works for long lengths....thank you, kindly!!

Use a longer piece of pipe so if it falls into the conduit you won't be f---ed

Deport them ALL, get rid of em now

What about when there is bends in the flex

I have a run of 90', which will require using four 25" rolls of the non-metallic conduit. What couplers can I use to join/connect each 25' run?

Looks beefy, is this superior to iweiss crimper? Need to make 6 gauge lugs for small motorcycle cable.

I won’t fit ! I got one side in but the second one never fits inside the box

stab on vs clip on? really. The one thing i like is the copper bus

Isn't it supposed to be taken out of 75°C column? (90°C column for calculations only when dealing with derating).🤔

Also I happened to buy SOOW and that wire is thicker than SJOOW. I purchased 12/3 SOOW.

I’ve chaged out batteries, now it won’t come on ??

phlegm rated

What is the distance between Spring nuts that is allowed by code?

Thanks for the info. Straight and to the point!

Genius

can't seem to find this website is it still up and running?

Your video made everyone at my job site think I was a genius lol thanks

Sometimes the easiest ones are the best ones thanks!

What if the piece falls into the conduit...what now

Thank you for the straightforward explanation. We were looking it up and got to some videos that were Beyond 2 minutes and that is too long. You kick butt I subscribed

FLIP FLOP

Thanks for the useful explaination

Are these something that the everyday consumer can purchase? Where would I go to purchase

Why not just use a k.o. seal and punch the right hole instead smh

I need a shirt I'm an electrician please send me one of these to show my fellow workers that I mean business 💯🙏❤️😀

Exactly what I needed to know. Thanks