This channel about automation and control systems. here you will learn about PLC, HMI, VFD, and its design. In detail, you will see communication between VFD, HMI, and PLC. MODBUS communication using ASCII and RTU mode. Also in my channel, you will see a solution to a video uploading problem. Guidance to create good videos and easy steps to upload videos on youtube and other platforms. Video solutions like video abandoned, Processing stuck at 0%. the setting of video property.
Hi, I managed to get the MS300 inverter to work thanks to your videos and for this reason I believe you will certainly be able to advise me on a request. I currently drive the motor in V/F mode through two wires and a 0-10V voltage across the cnc, I would need to stop the motor in a specific position if necessary, of course I have an encoder on board, how do you set the driver? Thank you
is there any way to save the Description from the video that failed to upload? I put a lot of work into typing out the description and I would like to save and reuse it but I can't get it to open.
thanks for4 the video , could you show us how you have connected the plc & hmi to the same modbus rs485 and what was the configuration in both plc and hmi
I have the same question. I was surprised that this was not shown on this otherwise very comprehensive and helpful video. I have followed all these instructions but I can’t make anything work because I can’t figure out how to wire the devices together.
Your video was awsome..but can u tell how VFD is connected to this setup because if Rs485 port d+ and d- is connected to hmi then how VFD will be connecting...waitong for your reply
