Great video i will fix mine now

Nice job

Lucky. Had the same problem on mine; but it was the bottom connection on the door that broke on mine.😢

I would have used heat resistant silicone to install the plug

What an awesome hack. Fixed my issue in 5 or less mins.

Thanks for this.

Thank you so much for this video متشکرم از شما آقای محترم امیدوارم همیشه سلامت شاد باشید

I am forever in debt to you sir! I nearly went crazy looking for the right answer while everyone else was saying “swap your relay” but never check the wiring! Thank you again and you got yourself a subscriber

I have an older Honda Accord. I believe I need to replace my thermostat. I’ve been having trouble with loosening the plastic drain plug. It’s just stuck shut and it doesn’t do anything it just won’t turn.

Excellent video brother, Thank you for your help.

Do I have to remove the thermostat when doing the flush?

Did you have to remove the skid plate? I'm here at the mechanic and he has it removed.

Thanks for posting video. I had exactly that issue 5 minutes it was fixed saved me a whole lotta time and money. Great work.

I need to do this one bad on my old girl. We have done the valve cover, crankshaft seal, the oil pump seal, and the transmission seal. And now this one is leaking bad on the engine, tran, and exhaust causing it to smoke. How long would you say it took you to do this process?

Do we need to drain or add oil before or after? Not sure if oil has to be drained before pulling cam plug. Great video.

Hehehehheheheeeheheh ty

Wish I had seen this yesterday before I changed the valve cover gasket. Good walkthrough.

Awesome video. Had a check engine light this morning watched the video and found out my hose is cracked too. Recently changed the intake hose because it cracked in the same place. Great video!!!

I have a 2004 Toyota Avalon and the AC worked a few months ago then the light started blinking then it never turned on ever again there’s no leaks and it’s full of refrigerant what do you think it could be ? Please help me

Thank you for helping

THANK YOU SO MUCH!

2006 Civic fan was making a buzzing noise. Inspected the fan and didn't find anything. Went to pick-a-part, found a perfectly good one for $13, popped it in, 3- T20screws, done! No more noise.

It's the HDMI .change it

Thank you for the video. Did you also use distilled water to do the several flushes? Also, it's basically impossible to find the original BQ 1 03 0004 Mercedes Benz coolant online nowadays. Is the Zerex G48 Concentrate the new one to use?

The latch won’t come off I pulled it uo and tried to take it off so I can fix the string but it won’t come off

It's so much easier just to remove the cam cover. Replace the little hall moon plug and install a new cam cover gasket. I do appreciate your video because I want to remove my throttle body.

Did you really need to erase the SSD? It was already formatted properly, and it was empty. You could rename the drive after installing the OS.

Thanks for making this video. I didn't know that this was a possible to have a leak here. Turns out I did. Like other commented, I replaced the plug by taking off the valve cover. But it doesn't give a good access to be able to remove the existing plug like your method does. But, there is plenty of room in that cylindrical hole that holds the plug to have two plugs. So, I didn't remove the old plug, I just put rtv in the hole and on the new plug and just inserted it in series with the old plug. I changed out the existing valve cover gasket and presto, no more leak. Thanks again.

You're supposed to take the valve cover off you fool.

Is the fix still holding up? Wondering how long until it breaks again since the tension is higher and still a small piece of plastic to hold it.

2 minute fix. Spent 20 minutes trying to slide the microwave from under the counter just to learn that I didn't even have to. The opposite side of the spring broke on mine. Which made it easier to fix. Just latched it to a slot in the door and done.

Good video. But you didn't give the part numbers!!

Your knowledge 👍

Did you empty half of the dish soap from the bottle before installing?

Thanks man, I fixed my Camry after I watched this video. I found that the socket was loosen. Thanks a lot...

Nice! I think mine is the exact same one. Thanks!

Perfect fix! Thank you!

Thanks bottom one broke for us today and the comments and you video helped 🎉

Did all that extra work for nothing really

This was my problem as well but the piece at the other end of the spring was broken. I had to gorilla glue it back in the microwave. The spring was also so tight it kept breaking again so my son and I had to use a combination of heat and hot water to help stretch it and it finally worked. I’m sure a man would have had an easier time. Either way, thank you so much for saving me a lot of money.

Good video ours just broke two years old and broken nothing last more than a few years total garbage

Worked perfectly. Appreciate you!

Where i can get that tube please thanks

Good diagnosis but horrible repair. To get that pin out of the connector you must first pull out that white plastic retainer in the inside and then use a small metal pick to push that pin out

Mine was broke from the bottom. I hooked on the hole on the side and it works great! Thank you for the insight!!

I couldn't figure out how to get thar trim off myself, you just saved me from buying a new microwave!

mine broke from the door side。。。 anyway to fix？

GOOD JOB

Great info!, I never would have guessed👍

I all of a sudden have a noise coming from my passenger side dash and it's very annoying at highway speeds. The noise is there with and without the air or heat blowing. What could this be?