Thank you very much this helped me my Traxxas stampede was not moving at all and I was scared it was broken then I watched your video reconnected my controller and boom now it works that you very much 🎉
My first truck was a 2001 Rustler with the Stinger motor and mechanical speed control. These trucks were made for speeds much lower than 70mph, but are incredibly durable. Mild upgrades are in order to reliably do that 70mph I would argue.
Hi if it’s not pairing following this then you may have a faulty transmitter or receiver so it may be worth visiting your local traxxas hobby shop to find out which.
On some of your videos you have comments turned off but I have a question about one of the reds engines you was working on I noticed the high speed needle was on the side of the carburator I have never seen that can you please explain that to me and how you did it and why please thanks
I had the same issue (CAN steer CANT move) I did what you did at 4:54 and it worked but only for less than a minute. I was very happy in that time span but now I’m not. I have the battery pack that is shown in the video but my question is do I need to get the LIPO battery for it to work?
Hi, It should work with the NiMh battery supplied. Just make sure it's turning on with a Red light for the NiMh mode on. Maybe your battery run flat after that? So make sure your battery is also fully charged both the NiMh in the car and also the AAs so pop some new fresh AA in the transmitter. Hope that helps a bit more.
Great video. I’m fairly new to the hobby. I thought binding was the problem with my latest TRX4. Wouldn’t do anything straight out of the box. Now up and running thanks to your help.
I have trx4 blazer a hobbywing 1080 g2 and im having a flashing red light on that and a solid red on the tqi reciever. Steering only..no throttle. Reciever wont bind. PLEASE HELP!
He I have this very Slash and it runs great but while running the car there are times when I need reverse and it will not reverse or go forward I have to repeatedly work the transmitter a few times well before the car goes forward again now get this if I dont stop the car completely and do running about face the car will not stall out, a little help please.
Sometimes the esc needs to be reset and rebinded to the radio. To do this remove the rubber cover on the top of the receiver. Inside is a 'set' button. Push down the set button inside receiver while you power on the esc while also pushing down 'set' button on top of the radio. The radio and car should be binded again.
@@passionateaboutrc ok thank you very much for that. I just bought my first one and its an Arrma Senton brushed 2s 4x4 so i dont understand much about them yet. So i need all the help i can get if i ever wanna do upgrades. My stock charger also takes like 6 or more hours to charge my battery packs. Which sucks... because i gotta wait 12 hours or more just to have to fully charged batteries
You may have a faulty transmitter or receiver in that case it would be worth a visit to your local traxxas dealer to see if they can help you diagnose which.
So I have a trx4 K5 Sunset Blazer. I recallabrated it but I didn’t hear beeps at the end, When it starts now it’s not blinking green and it red light. BUT IT DRAINS THE BATTERY FAST. When going to use it. But I don’t know if it is the battery. Traxxas NIMH 3000 B. I changed the battery but I didn’t use it Right way.
The ni mh battery doesn’t last as long as a lipo so I may just be the time you will get. Also you should charge a ni mh just before you want to use it and just be before you pack it away for a while then recharge just be fore you use it again to make sure it’s fully full every time you run or it will be half empty as they effectively leak some charge over time on their own even without being connected or used. Hope that helps.
Hey man thanks. I hope it’s not the battery. I did have a Traxxas 4200 NIMH battery and it went bad. Sucks there no 2 or 3 party batteries with the new Traxxas Connecters.
