Haha the zip tie that was included wasn’t waste it’s meant to be used to tie up the wire harness that’s is left dangling when you remove the symposer valve so that it doesn’t get caught on the shift linkage.
They held up great for about a year, then i decided to upgrade them to a full RGB. I didn't complete the upgrade tho because i didn't step down the voltage
@@fenger2804 If you look up ws2812 lightstrip on amazon, you will find some. the brand doesn't really matter. I am trying to finish the rgb version, but I didn't add a power regulator and burnt out the LED. you can see what the shroud looks like on my insta @ranger_st3
@@gofast8144 I've had it on for over a year. The only gripe I have is that they don't provide some other mounting points for the intercooler. The stock mounts do work, but I am about to have some extra support welded on so I can drive it harder.
Aubrey Champagne yikes it sounds like the prices is going up and it’s no longer a budget FMiC. I was afraid of that: that stinks thanks for reply. I’m going with a CPE or mishimoto just for ease of mind. Thanks for replying
Dont use wire nuts for automotive wiring. Properly solder or use a quick tie in crimp connector. It's only for fogs so it'll be fine but it's better/easier to just do it right the 1st time
Wait... Is this device made of 2 random wires attached to 2 random forks UL listed?? I know, it's a dumb question.... OF COURSE it is!! Otherwise it wouldn't exist, right??
Depo racing 3.5 do I just install and good to go for 2014? Any hole drilling or anything mod that's needed? ( I am not too good at it, can pretty much just handle plug and play lol) grill shutter I have to take that out to make room for depo IC?