??????

В холостую упала никого не придавила😮😮😮

CNC-Hell

Where are you😅

Hi, nice work! What size of rotation table do you have in your tos? also what x/y/z travels?

Safety first

Made in China fail

A lot of hrs in those parts

😮😮😐🤯🤯

Se acabou😂😂😂

Never heard of a chip breaker insert?

縦旋あるある( ´-ω-)

Das nenne ich mal Work Live Balance😂😂😂

Someone always asks me why i dont react when shit goes wrong, i constantly have a dead pan look on my face. Because I'm contemplating what to do lol not panicking like everyone else in the car i just drove into oncoming traffic

had do be split allready and take too much when hit joint and anyway it was too long for those chucks lol

why wasnt he using straps?

Not aus wäre schneller gegangen

Скажите пжалста, вы являетесь ярым поклонником и пользователем AICut?

И эта одна из причин, по которой Я из токарной группы станков - перешёл на обрабатывающие центра сверлильно-фрезерной группы - нет длинной стружки. Эволюция Моя собственно была такой, был токарем, надоело крутить ручки и убирать станок от стружки и подметать пол, стал наладчиком ЧПУ токарной группы, надоело распихивать сружку по ящикам и прыкать по стружке утрабовывая её в ящик - перешёл на обрабатывающие центра.

Это что за расточной монстр

Они что взяли две половинны детали и зажав их - решили обработать?! АХАХАХА)))

Lack of common sense amd proper training

Useless

Hope that chinese stuff has a warranty......

I've never seen a lathe so big in my life. I'm guessing there are lots of things that are very large bits that need precision engineering like windmills exc

Lo importante es que no retrocedió, aún cuando casi le caí encima 😱

wow.....

Always remember to stand back... one sheared bolt somewhere and splat

Ahhh Yess the good ol' E-STOP button! There only but for the grace of God, and a rare few who are paying attention, and choose to actually press it.

Bad manufacturers and engineers.

Some set up alright, do they have a caliper to check it 😂

面不會震刀嗎？

That's sucks I seen those split bushings before come apart but not like that lol

Und Zack und ist viel Geld zur Nichte gemacht worden

Нормальна така втулочка

Depois criticam quando as empresas robotizam tudo.

Muzyka dokładnie w punkt

That's one way to cut a cylinder in half? I'm guessing it was welded and it failed?

Lathe said it's Friday 3:30..... I'm done 👍

That'll polish out.

Порошковая сталь даже самим китайцам боком вылазит

Low jaw clamp to prevent egg shaping, means you take smaller clamps, split bushing. Wheres your band straps.?

How did it just fall apart like it was glued 😂

The tacks broke 😮😮

Магниевый сплав горит?

Material was way too tall and the little jaws couldn't support it....slower speed may of helped

That's gonna cost 1.35

Now that's a chip load!😁👍

Now That's a big boring head!

That was an expensive mistake