Just bought one and it is working on my 2012 Chevy Spark but not working with my 2018 Suzuki Vitara. It connects via BT but when you try to scan it cannot establish connection. Any advise? Thanks.
I bought one for my wife's car and she absolutely hates it. The sun interferes with its view certain times of the days and does so to the point where it's not viewable at all. Personally, when I observed it (I was skeptical at first) and drove her car I was in agreement. I was ablle in certain circumstances to fenagle the position of the camera to avoid most of the bad reflections but still, they were very distracting rendering the rearview dangerous.
That throttle display you can never see during the daytime,and it's been around for way too long. Also there are better options than the same OLD red/yellow dual and eco buttons. I relayed this same message to GEOFOUGHT CO. that keep on making new scooters using those same OLD control buttons. For the throttle, and eco/ turbo buttons. if they used the old dualtron (green glow displays) that would be a whole lot better because you can see that display CLEARLY in any light.
My Hansgrohe Talis Faucet has been great for years until I developed a leak because the ceramic cartridge need to be replaced. I ordered a replacement for about $64.00 delivered from Amazon. I reviewed the Hansgrohe video showing how to replace the part. Step one, turn off the water, step 2 remove the handle by loosening the setscrew. That's where things went bad, real bad! I thought maybe I hadn't backed-off the setscrew enough, so I tried to back it out further. What ends-up happening is that the setscrew will hit the inside if the handle, and stops turning, If you force it, you will strip out the allen head (as I did). The setscrew head is larger than the access hole in the handle, thus the setscrew can't be removed without removing the handle first. No matter how I pulled, yanked or banged, it eventually became obvious there was NO WAY that handle was coming off. If you can't get the handle off, you can't replace the cartridge. I was left no choice but to cut the handle off with a Sawzall. Of course this ruined the handle, but I could now see what the problem was. The handle was GLUED to the nylon cartridge arm. I purchased this faucet from Costco brand new and installed it myself, so I KNOW "I" didn't glue it on, so who did? Why would Hansgrohe do that? Just to sell new faucet handles? This model was had the Hansgrohe Talis C Stainless Steel Optic. I went to the Hansgrohe website and found the Stainless Steel Optic handle was no longer available. So now I have to buy a new $400 faucet? WTF? OVER!! NEVER AGAIN!
Its not useless, far from it! I have this calculator and utilize the scribble pad for reminders, notes, sums I require, answers I've obtained and a whole load of other stuff I'd otherwise be scribbling on bits of paper. So the notepad is very handy, every calculator should be equipped with one.
Had some it was extremely dry. But I overcooked it so maybe that was a factor? The other Somos rice I didn't overcook and it was dry also. Maybe its a locational issue? Perhaps not all Somos factories prepare the rice the same?
Just bought the same hedge trimmer and very happy with it plenty of power cut hedges all around the house and a storage house plus. Some hedges for a neighbor on a full charged 5ah battery and still 3 bars left on battery after I completed the hedge trimming job house was fairly large brick home
I’ve had my tower fan for almost 4 years aswell but never knew what the numbers were I would always just turn it on and put it to the highest setting till this day I just searched what these numbers were meant for
