Would this possibly be the same problem for Renault Kadjar?? Car is driving fine for months with Anti Pollution light on just cant seem to clear it. Would sensor be same place??
@jessnielsen3771 for 0 sekunder siden it takes under 5 minuts with af grease gun filt with injektor clean and connected to the pipe with a stell armed hose
i have a 15 plate Renault trafic sport is the module in the same place as that one? also do you know where the buzzer is located for them as im told it could be tha tat fault also sounds like its behind the passenger seatbelt is that correct many thanks
What mileage was on this van I’m currently on 88k and engine light and check anti pollution came on. Van runs fine but sometimes has intermittent low power for a briefly then clears out. No smoke or anything from exhaust
@@hakimauto9314 thanks for reply I’ll give it a look today also gona change the Air flow sensor. Just waiting for my Carly obd to turn up to check the fault codes. Thanks again
ive replaced my rear wiper arm vw mk5 golf n now not working but fuse ok but cannot hear the motor working so looks like a new motor replacement ... but unsure as been told check the relay thats situated behind pull down tray drivers side n i imagine audis are no diff so will be checking that first before i strip the boot lid n replace the motor...But i have no sound at all coming from the motor ?
Your Video saved me a fortune, lol, past week I have been going over fuses, relays, it was suggested new dash, new ign switch, re programe the ECU, key fob needs replacing, yesterday I saw your vid, today, exactly the same, corroded earth points, I now have a hole half the size of yours, lol, thankyou..... symptoms were, no dash lights, no crank , imob on all the time, no power to the engine management relay, was fixed in 20 mins.....all the best bob
I'm sure you already found the answer for this but if you look through the fuse there's a small piece of metal that joins the two metal prongs of the fuse. This is the part that intentionally breaks if there's a problem. If the piece joining the two prongs is split in 2, it's blown.
The wiper motor stock sometimes because of the water gets inside the motor remove the wiper motor and tried to clean it and put it back it will work fine
i tried removing that big vacuum hose in the beginning of your video that "clips" onto the intake. i couldn't get it off, i ended up leaving it alone. i didn't want to break the plastic part and not have a replacement. if you remember how the clip gets undone I would appreciate it. i really want to clean up all the gunk built up in my intake but cant because i can remove the whole thing.
