looking for swapping some switches as my 2wsx and f1 aren't working, can you suggest some website where I can find compatible keys. Do I need to look for something specific or any kailh switch would do ?
The only risk of using buck/boost converters without current limiters, which are cheap and ubiquitous. Lithium batteries can and will pull maximum current and you can get run-away heat build-up. Be sure to size your buck/boost converter appropriately or get one with current control that actually works...or you risk melting something. It's the same issue people run into when using a buck/boost converter to run high-powered LEDs. I know from experience.
So Router does not need antenna inside Room, to transmit wifi, are both antenna that originally come with router are for receiving 4G signal, can this also be done with TPLINK MR200
Hi do what to do when its heating less then what it is showing in digital display say for examples in display it is 350 degree centigrade in digital thermometer it is 300
I built a welding device using the ideas presented in this video and it works great. I used a 340 CCA lawn and garden battery and an atv relay. I bought some diodes but am using it right now without a diode to see if the diode is completely necessary. No problem so far but will install the diode if I start having a switch problem. My switch will handle around 6 amps and no problem so far. I assume the diode is only to prevent a current surge from the collapsing field of the relay coil. I have no idea how much of a surge would be expected but so far a 6 amp switch seems to handle it. The welding quality for this setup is far superior to anything I've tried so far. Thanks to DIYINDIA for the concept.
Just a small tip, you can use one of the Load Output of the Victron MPPT to drive the relay, and since you have a LFP battery, the MPPT has a 2 Minute delay before it switches the load output on/off. So if there is any spike load in home, it will wait for the voltage to stabilize for 2 minutes, and then drive the relay.
