Hi. They are rock well delta rated at 52,000 each. Running a fiat Alice tug boat engine 18 liter full inter axel wheel lock deployment. 18 over 2 speed auxiliary. AH BEAST
I’ve often wondered how much these transports cost, how often they are used and how much they charge. As far as the music goes for videos like this it’s the best music I’ve heard. Thank you
I welded at the Trail King who built that trailer. Some of those depending on if its a drop deck like that of a suspension set up will cost upwards of 2 million. There is a lot of time and welds in all of their trailers. Some of the regular HDG trailers I welded on were 100,000 dollar trailers, but they had every option on them, tons of D-rings and lockable chain boxes, 4 axle, 2 full lift, chainable axles, the works. Can't say anything on their trailers now, haven't worked there in 5 years and heard its not as good as it was when I was there.
Просто дали какому то "карманному КБ" в США попилить бюджет. Иначе оправдать этот иррациональный бред никак. Плод больной фантазии инженеров-кретинов в США. Зачем так сложно? Хотя о чём это я? Это же традиция западной конструкторской мысли - делать всё очень и очень сложно, затратно. Ху*ня это!
Вещь которую перевозят в десять раз меньше самого автопоезда, какой смысл его вообще делать таким длинным? Перенапряглись инженеры с созданием такой махины ,бессмысленно и не экономично.
А Вам известна, какова масса изделия под тентом? Не предполагаете, что там может быть и 200 тонн? Смысл, как минимум в том, чтобы не уродовать дороги. Там оси и в длину, и в ширину раздвинуты, чтоб нагрузку распределить на большую площадь дорожного полотна. У нас в районе мост через Волгу строят - так за 1,5 года так все дороги расхреначили самосвалы с песком и щебнем (по 60 - 80 тонн ГРУЗА!) , что на обычных машинах уже и ездить страшно. Если Вы думаете, что в США не умеют считать деньги и другие ресурсы - то поверьте, Вы глубоко заблуждаетесь.
That setup isn't going anywhere near fast enough for the wind to hurt it. They've been hauling similar rigs by where I work, for a new power plant, and I haven't seen one top 25-30mph yet.