greeting! For huydrulic chuck cilinder pisto I am contacting you regarding the O ring of the main piston. The internal dimension of the O ring channel is 144.7mm, what are the dimensions of the rubber required in cross section exemple (fi144.7x fi6 or larger), can you specify the diameter of the rubber that you used, thank you very much
greeting! I am contacting you regarding the O ring of the main piston. The internal dimension of the O ring channel on my piston is 144.7mm, what are the dimensions of the rubber required in cross section exemple (fi144.7x fi6 or larger), can you specify the diameter of the rubber that you used, thank you very much
No good practices seen here. Cleanliness is the most important thing when working with those utterly expensive spindlebearings. Every hobbyist would do it as shown, for a professional spindle repair this is nuts. Sorry
I'm surprised that the spindle nose wasn't polished up on the outside ( 6.17 ), I know it's only cosmetic, but it would finish of the job. I'm also surprised that the bearings were just slide on the spindle ( 5.46 ), I thought that they'd be a press fit.