@@efrainsubiabre1228 sure if u really need it or share your email id i will send u the arduino code as i have already built one in another vide u can check my channel
@@basicthoughts8054 when battery is 0, when i plug charger its charge fine but for example after 30 min charge, i can use headphone noproblem but if i put in charger again this time both lights open and cant do anytying until battery goes 0
There are 3 wire versions and 2 wire versions from battery where 3 wire version 1 wire acts as temperature signal input to circuit and a resistor is used as temperature sensor , on some models or knock offf ones uses these resistor on main circuit amd avoid the 3rd wire running through wires to battery check how many wire coming from your battery if the wires are pinned and insulation is removed it will conduct voltage to the sensor wire and circuit detecs there is problem with circuit and it halts thia also cause both led to glow togather once charge drains completely and no more voltage tingling sensor wire restarts the circuit or at a point where sensor wire matches to the resistor saying now temperature is ok , u can bypass it by connecting resistor directly on main board by measuring resistance on battery side where the resistor is or remove resistir from there and directly connect on main board disconnecting sensor/resistir wire going to battery on some models resistir is inside the circuit on battery protection circuit which is taped with thermal tape/yellow tape, sometimes the 3rd sensor wire will be running as an insulator wire for positive or negative wire i dont remeber well, u can check on circuit side how many wires are from battery ie 2 for left and 2 for right speaker and 2 for battery terminals and an extra wire soldered on main board resistor value is around 10k or 100k i belive
Control board check kare voltage variation hoga , picture tube ka problem haitho 3 mese 1 tho kam karega 3 kaam nehi kar rahahai tho board ka problem hai
What ever pins are soldered on transmitter should solder in receiver so that it will pair if use multiple transmitter with same pins soldered works as mutiple remote for 1 receiver
Wow, this is awesome! Once he finalizes the design and goes to like pcbway to clean up the boards it will be beautiful. Sir if you see this, I am highly impressed with your ingenuity!
@@Rashiditworld u need to chek lcd resolution and nunber of pins in connectors that usually writes in specification if these both are same u can swap and try
