Hi again i sent you the wrong messages I meant to send you Question I have a rover L405 3.0 supercharged Once the original pullybus removed dobI have to mill down the snot end v4 heating up the new pulley on? Or? For the 3.0 It's just a heat up and slide on the water cool? Just wondering bc I read the 5.0 Has to be shaved /milled down Thanks alot
I know it does My question I'm asking if I want an additional 4strips Instead of the footwell lights Can you swap the two? So I can have for my console instead of the foot
Hi Questions To remove that center bolt it looks like your going clockwise. Isnt removal counter clockwise? 2. A upgrade smaller pulley just slides on and permanently bonds Without using the center bolt? Meaning that bolt is only for the stock setup? Thanks for your support im new to this tune stuff.
Thank you very much for taking the time to make this video. The upper pulley removal and installation was exactly what I was looking for. All the best, mate
When do you think you will do the lower pulley? Did you do a remap after putting this pulley on, or did the car take it and make more power already? I imagine the remap would allow for more power since the blower bypass valve probably regulates to the factory boost levels regardless of blower output.
Unfortunately not! I have a couple of videos to upload on it but due to serious time constraints due to work, we have decided to let some of the work be completed by an external company.
There is very little room for the bottom pulley unfortunately, the ideal thing to do is replace both, in our case it made sense just to change the smaller pulley.