I built one yesterday when removing the wheel bearing, just buy a right size thread rod, using nut and large washer as end stopper. dumbbell plate can be used as the mass, so I can easily get 5~10kg hammer...
My gas gauge stopped working on mine after a year. Do you think it’s just the gauge and where online is a good place to purchase? Bobcat wants too much for oem. Bobcat wants 50$ 😂
Toyotas are excellent engines. Take a little brush used transmission or used differential oil and brush oil over those bolts. It stops corrosion + it makes them easy to take out when you need to work there. I love applying these oils over anything that can corrode in a vehicle
This is bullshit I have a husqvarna 562xp running a 24 inch bar and mine chews wood fast! Someone needs 2 file thar chain on this 562xp n file it RIGHT! I don't care what u have 4 a saw a bad chain or a bad file job on the chain
this is impossible for a Stihl chain, it's completely new, it's not fair, it's not done like that, mate, layers on the new board with a chain and the result will be completely different
we originally owned 3 tuff talk m helmet set and i bought 2 more so we have 5 total. roughly a year to a year plus of service. ironically we had two sets go down with battery level low or complete failure as soon as the extra 2 sets showed up.
I have to disagree on easiest way to install the new up pipes on the turbo. Un bolt the turbo from the pedistal and clamp the y pipe to the turbo then bolt the turbo back on then bolt the up pipes. That clamp is such a pain just dont even try doing it with the turbo bolted down
We work in torrential rain and snow....this is the only reason I haven't bought a set and referred numerous other people to this company...get your shit together sena, you'd have a lot more customers...also figure out a way to have batteries that come out of the muffs so we can have multiple batteries charging and ready to go. LFGOOOO
In a hurry i use 1imch rebar and a crowbar. Takes muscle and someone else to drive the tracks . Do it on sevice calls. But honestly removing that wheels makes sense.
"My 201TC fell down to the ground from 40 feet up". Thats like dropping a normal saw off the back of the truck, so you're good. 🙂 They're heavy, but solid!
Thanks for the vid! You could have gotten that crud out of the bottom. That is remaining compound that was on the old cup. I used a long pick while using the tip of a air hose blower on the tip of a screwdriver to cover the hole. It picks right off.
I just did this on a 2002 2500 Cummins put new hydro, pump, and vacuum pump bled it and worked fine but customer says everything stopped again. Going to get it back to shop this week but really no clue what to do next.