Life saver so easy my window will go down as soon as I open the door but when I will close it it would go back up n doing this easy steps actually really work thanks so much 😊

Thanks, for me i really didnt even have to take off the console since i was just realigning the radio, but boy having one of those screw holes being behind the screw frame was just awful. I was still able to fix it and the whole thing is looking great ill just neeed to replace the center console lid.

Thank you it worked , but can it be permanently disabled ? 2006 4.0 if so please post thank you brother.

Thank you!

GREATEST!!!

It worked! Ford was going to charge me $120 and said it would take 30-40 minutes. Your video told me just where I needed to look - just took me a while to get myself down in there and out! Still only about 4 minutes total. You are the best!! Thank you , thank you!

A little tip... Instead of trying to get the hard to reach clips to release the cables from the headlight... Twist and remove the light from the housings and after the assembly is off remove the bulbs.

Thanks😊.... excelente explicacion es usted muy profesional...saludos.

Mines is on the top. Easy peasy. #3057

Thanks for uploading this, saved my mom a whole new front driver side seatbelt

Luved those. Beha. Ht camoro. Steering. Wheels😊😊

Hi Martin, all Great videos, I have a question, i just bought a 2008 Ford Mustang V6 Deluxe, Having a water leak issue on the passenger side, I cleaned and pulled out the 2 drain plugs, replaced the seal around the top door frame, replaced the gasket on the cabin filter and siliconed all the top clip retainers and replaced the gasket around my side door mirror..... Still getting water from right above the side fuse box. Right above the Fuse box, theirs a gasket type plug with wires going right into that fuse box, Water is leaking in from there when it rains or when I run my garden hose into Cowl vent on the cabin filter side.... Any idea how this water is getting into that particular location right above the fuse box. Thanks, any ideas or suggestions would be great. 😇

Thanks for the very helpful video on this repair. My regulator cable was broken at the plastic end. I purchased a new rear Motorcraft regulator $150 which came with a motor and I was able to simply swap my good glass over on 2 nuts. Of course I dropped one of the nuts holding the trim into the abyss and while fishing it out I dropped my iPhone down there for good measure 🤦‍♂️!! I also lubed all the top folding pivot points and the top moves much smoother. Good luck everyone!

thank you fir the help!

Thank you so much. I thought you were just making it look that easy. 😂 Thankfully it was. 🎉

7/16ths wrench...grrr...this is why I don't buy American cars. (Fixing mom's car) Thanks for the video!!

Thanks. Just what I needed! Yours was the 2nd video I watched and far better than the 1st one. (The first guy neglected to mention the screws, and he put the filter in upside down.)

Not sure if you monitor these anymore, but just bought a 2007 mustang V6, knew nothing about it, or mustangs in general, and have watched and liked several of your videos so far that have proven very helpful to me starting with the one about emptying out and cleaning out the drains on the firewall. Also, would never have found the cabin air filter, without your video. Thank you so much for taking the time and putting the stuff out there, even though things seem so simple to those that do it every day, to those that are new to it, videos like this, make it a much better experience! Even on how to change the wiper blades while it seems of menial task, I’m sure you saved me several four letter words, trying to figure out how to do that! again thank you for the effort!

Let me go try this right now I read a comment to do it with door open let me try it closed

Thank you so much... Now I can change my light without any hiccups... Wow, so easy!

Martin's Used Cars, great video, you just saved me 100 dollars and a trip to the dealer. They said that takes an hour to find out. They know but they want that money. Thanks, brother.

Not sure if it's the hair or the way he speaks, but this guy has major Dad vibes

I have replaced my blend door accuator both the top and bottom on pass side i fixed the issue and the air came from all vents for about a week then stopped working again what or why is this happening do i need to replace the other two as well?

Actually I got your technique confused with another you tube video, but you're still smart....

you're the smartest guy on you tube. I have tried all methods described on You Tube, and unscrewing the old struts is the only thing that worked. The ends still had to be pried out with the combo of a flathead screw driver, a small "S" hook, and a pair of large tweezers. The ends did not simply pop off.

2011 Jeep GC here. I have the same issues as you. Cold air driver side, warm air passenger. The other issue is my blow motor randomly cuts on and off. I replaced my blower motor, HVAC resistor, replaced fuses/relay, etc and still cuts on and off. Wire connections seems to be goof as well. This has to be the fix because I don't know whatelse I could do.

Tengo un problema ya e probado con varios controles y cuando quiero abrir o cerrar el carro el control funciona solo algunas veces que podrá ser saludos

Is this similar to 1977?

Hey i like your video it helps me out quick thanks

The chrome piece wont snap back into place, any ideas?

Thanks for the video. The 2013 Ford Fusion Hybrid is the worst vehicle I’ve ever owned. I hope they fired the engineering team. Wait until your battery dies and your jumper is in the trunk but there is no feasible way to open the trunk unless you have an 8 foot arm that can reach through the tiny slot.

Keeps telling me on oreily that 3057 doesn’t fit my Edge

Good video

Este es el mejor vídeo que he visto para poder reemplazar un filtro de la cabina de un auto

Just wanted to add one thing, NEVER leave the wiper arm sticking up like that after removing the old blade. It is spring loaded and if it decides to slam down onto the windshield it will crack it. Remove the old wiper blade and then gently put the arm back down on the windshield until you are ready to install the new wiper blade.

This video just saved me so much money 💰. Thank you😊

Thanks 👍

Did you have to remove anything? I have the 2012 SEL and there’s just enough space for me to remove the cap. I can even touch the bulb, but there’s no space to turn

What if Yu already Lockd out

Thank you, easy to follow for my Volvo v70 2003. It was burnt out, got the "check stop lamp" message every time I pressed the brake. Got the bulb in a 2 pack for less than $7.00 at Napa Auto Parts locally.

very good job mister I will follow your advice very kind God bless you

Sabe cómo reparar el cambio de color del cluster Mustang 2007?

This video was helpful😀

Thanks going to try it

I’m having this same issue, evap code and I saw your video and I looked mine was cracked and then snapped on me. My car won’t start because of it. Once I get the part in I’m gonna replace it myself but I’m worried the car still won’t start after I replace. Do I need to reset codes or something after I fix it? I got electrical tape on it now and car still won’t start

Excelente

If anyone can help me what are the first 2 10mm screws called mine are rusted and broke (all 4, 2 on each side)

The passenger seat switch that is linked on that listing does not fit for a passenger seat on a 2011 ford edge sport. I didn’t realize it until I got the old switch out and it was much smaller. However I reconnected it and it is fully functioning (for now) and I just won’t allow anyone to move it just in case 😂 thank you for this video though because now the seat usable again as it was stuck too close to the airbag for anyone to sit there 😊

It's sad but I've had to watch this video several times. Pretty much every time I disconnect my battery. Lol

horrible video