🤩👍

Good job thank you

🦴🐶🦴

🏝️

❤

🔥

That was very helpful

Good job Bud, I need to do the same on my '01 lifted Grand. Thanks.

You made this look very easy. I am fairly inexperienced with vehicles in general, I have the quadra track 04 grand cherokee. Will the process be the same as in this video so I can follow along? Thanks

You made the snap on salesman rich! LOL

Why did you need to replace them? Well done video

Good tutorial and thumb up.

Straight to it! Very well done

axle shafts brand??

Great video, thanks. I've done it a couple times on a 97 jeep, and have busted cv joint on my 2004 jeep I need to do soon. Thanks again, and you gave torque specs too

I've been an auto mechanic for many, many years, good job! I just needed to know if the hub bolts were inverted torx? Mainly because one of my inverted torx sockets is broken from a hub bearing bolt! For I have walked away from all the electronic bs after 39 years! I started on points , carburetors ,u joints, ball joints and all the real mechanical parts to a vehicle.

Great video on how to do this job. I appreciate your help. I’m going to tackle this job soon. Thanks bro.

This is really good video with the torque spec

How did you get it in so easily im having a hard time

nice clean vid!!

Awesome job

Is the axle shafts not clipped in like the rear axle shafts? When I did my rear axle shafts I had to take my dif cover off to take off the clamps.

My Jeep is 04 quadra-trac2 but they don't show it at Auto store they offer select Trac and a different 1 what did u choose select Trac?

Great video

Excellent video. Thanks.

Very good....💪🏻👍

Great job, thanks for making the video

Nice

Can you explain why you changed it? It looked fine. Was it doing something in particular?

Does the new cv axle suppose to spin when you install it? I mean if you try to spin it by hand and it does spin is that ok?

That looks clean and neat jeep. The stuff I work on is rusted and junk. I got my work cut out for me..

Can you take the bearing and shaft out at the same time, I have a cross threaded spindle nut and it want come off without cutting it.

Thanks

Thanks Jon was a big help on some work I had to do !! God bless bro

Thanks for this Jon it was real helpful for some side work I am doing !!

You make it look easy, great demonstration

Great Video full of information