Jeremy Kern

5
24 986

Комментарии

@rackdaddy6368 6 месяцев назад

Did you reinstall a new race in bearing ?

@edwardprice140 11 месяцев назад

I love all bands, big or small.

@andrewroberts5859 Год назад

very cool

@brandonthompson678 2 года назад

Thank you for this Video. You actually showed most of the steps so that was GREAT.

@MOTORHEAD8835 2 года назад

Good video , 1 thing I’m not seeing anywhere is the actual drop bracket orientation for the carrier bearing. Some guys may snap those bolts off & have to remove the drop bracket & if it’s in a backwards orientation that will definitely cause problems since it’s angled.Great video though!! 👍🏻👍🏻

@geneapodaca1597 2 года назад

Good video. 👍🏻need to replace the carrier bearing on my ram soon

@angelreyes4618 2 года назад

Awesome vid thank you, God bless

@wyattrasmussen69 2 года назад

Do a video on how to clean the carborator

@leonardocontreras8070 2 года назад

How big was the pole you used to press it in

@jeremykern9071 2 года назад

Just a piece of pipe I had handy that fit over the end…I am guessing it was 1.25” x 3 ft long or so.

@FahadBanjar 3 года назад

How many hours need to finish work??

@jeremykern9071 3 года назад

I think I did the whole job in about a hour.

@jackg3892 3 года назад

You never showed the clearance for the front of the bearing and drive shaft

@jeremykern9071 3 года назад

I am not sure what you are referring to...I positioned the new bearing tight against the machined should like the OEM one. Once back under the truck, lined everything up and installed bolts loosely to ensure fit before tightening.

@sisco_rl7160 2 года назад

@@jeremykern9071 you said around the 10:00 mark that you needed to double check your clearances…how do you know what the “clearances” are supposed to be?

@onlyDave1 3 года назад

Wow thanks so much for your post. My 350 is a few years older, but looks identical to your engine. Going to make my job way easier than I anticipated!

@mjrazoful 3 года назад

Can you post a link to the puller that you used?

@jeremykern9071 3 года назад

I used an OTC 1036 puller from Amazon. www.amazon.com/gp/product/B000O8243Y/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1