I want this car because it’s one of the last modern convertibles with a manual top. I don’t like all the extra electronic garbage, and I don’t mind manual tops. It’s on my wishlist of cars.
Thank you for this video pretty good idea lol I don't walk on my floors at all with shoes and that has pretty much kept my white rabbits whitest can be even their little furry bottoms of their paws. I have to shave some of the fur off of their bottom of their paws as well and I'm not sure if anybody else is realized they have to do that or maybe just my white rabbits because The fur grows pretty thick on the bottom of their paws and I'm wondering if it gets uncomfortable for them after a while so I trim them down and they're happy and they're white so it's easy to see that they're clean lol
What did you use to trim their fur? I was considering doing this with how dirty my rabbits bum is but i dont know whether to just slowly clean it. I dont want to scare her
Omg. Auxiliary is when your unit can’t keep up with very cold weather and the electric back up heat kicks in. You don’t want to see auxiliary flash on your t stat. Your electric bill will be very high if it does. How was your charge when you checked it with your gauges. Were there any left. Haha
I think you have put your finger on what a lot of us are experiencing. In mine, the cannister is breathing ok but there is gas in the lines to it and it won't fill. Also fumes. Clearly not venting from the tank. I can disconnect the hose to the cannister and it just dumps gas. Being a 2002 EV, it is more complicated and there is a set of hoses going up the fill tube for additional venting during fueling, I think. I imagine that the gas backs up, enters the fill tube vent as it shuts off the nozzle and then gets trapped at the rollover or the other actuated valve and can't reenter the tank as it normally would. I'm going to try pressurizing this line as you say. A little harder due to all the hoses in the 2002 but hopefully I can pull it off and won't have to drop the tank in a campground! I've used my 12v tire pump to air out the cannister before when it had gas and it's a nice little tool when on the road.
Mine stopped working very quickly (a few months). The screen has lost all the contrast and it's practically unusable. Too expensive for such a short lifespan. Has anyone tried to dismount it??
Evaporator coil got a major leak after only 6 months. Warranty sent the coil weeks later. I had to pay the shipping. and the same thing happened again. So I had to pay a technician twice for that install plus twice had to refill the freon. I already spent more than what the unit is worth. Plus I had to go weeks with no AC. Then finally the compressor went out in less than year. These Mrcool are made in China @franklinyoutubehu2349
In my case, I don't have any "current" exterior condenser unit. My existing air handler still needs the heating (for backup heat 60A) and fan circuits (30A). I think code also requires a dedicated circuit of the correct amperage.
I got a little dish of water for my bun and dipped his front paws in to clean them off. He still hated it, but no more pee paws or eye problems hopefully. 😅
Attraction & repulsion b/w charges depends on electric flux density. Higher density pushes & lower density pulls. Electric flux is made up of quantum particles & is different from electric force. Like charges can stick together if we remove flux density b/w them as in atomic nuclei.
This really isn't any different from what I'm saying except that I use positron/electron dipoles instead of the vague "quantum particles: you refer to and I use standard wave mechanics instead of "electric flux density" which is another vague concept. Explaining the actual physical difference between a positron and electron is still impossible to describe using a "flux density". This is why I employ the concept of "phase" to provide the needed physical difference to create regions of lower and higher pressure. It is the only way I have found for two identical objects to have opposite properties. Also, see my "cubic atomic model" which explains why atomic nuclei are not made out an illogical and impossible proton nucleus. Thanks for your interest.
@@franklinthuYou have an excellent explanation. What I could not understand is ringing of charges & emission of waves. Ringing needs input of energy & charges emit wave when accelerated. Stationary charge placed close enough pull & push w/o any energy input. Please clarify. A charge is surrounded by an electric field. My conjecture is that electric field is made up of sub microscopic particles having opposite orientation for opposite charges. Strength of electric field of a charge depends on density of these particles. When like charges come closer density of particles b/w charges increase due identical orientation & decreases for opposite charges. Like engine cylinder vaccum pulls piston & pressure pushes. Quantum particles are like molecules of gases in an engine cylinder. I think quantum particles are undetectable. There is no scientific evidence for such particles I am only speculating. Space around charge is different from free space. No one knows what electric flux is made of. My guess is it is made of quantum particles.
@@franklinthu Your expectation is more convincing than forces arising from exchange of vertual photons. For emitting photons charges require energy input. In your case also for ringing the charges & emission of waves energy input is required. For emission of waves charges have to be accelerated but stationary charges placed close enough also repel/attract. My conjecture is that electric field around a charge is made up of infinitely small particles which have opposite orientation for opposite charges. Density of these particles b/w charges increase in case of like charges & decrease in case of opposite charges. Higher density exerts push & lower density pull force. This is analogous to engine cylinder where lower pressure pull the piston & higher pushes the piston. Strength of electric field of a charge depends on density of quantum particles. Density increases towards the center of a charge. This is the reason force gets stronger as charges get closer. There is however no evidence that electric field is made up of hypothetical quantum particles. Just like graviton it is only a speculative particle.
@@zakirhussain-js9ku I would definitely say an "energy source" is required to power the attraction/repulsion. This is why I use the analogy of a bell ringing at its resonant frequency. The energy to create the electric field comes from the action of the particles hitting each other and generating a resonant frequency wave with opposite phases. Your solution of particles with opposite orientation doesn't solve the problem since I know of no physical examples where such orientations would cause regions of lower or higher pressure when interacting. Nor does this solve where the energy comes from to create forces. Phased interactions definitely produce high/low pressure and has been demonstrated experimentally in mediums such as water. I would predict that at zero kelvin, charges will lose their electric field which may help explain why some ultra-low temp experiments appear to mysteriously "lose" atoms as they may just fall apart at 0 Kelvin or superconductivity which might be explained by electrons having reduced or zero field strength.
@@franklinthuConstructive & destructive interference of waves is a scientifically proven phenomena. Wave interference can produce positive & negative pressure b/w charges. No issues here. Problem is, stationary charges can't emit waves, yet they experience force when placed close to each other. Since force b/w charges is a noncontact force, charges don't need to hit each other. Hypothetical quantum particles could be thought of as out of phase submicroscopic photons around opposite charges.
It's basically a 1 valve radio. It's simply does not have enough gain to work. The second valve is just an audio amplifier, it's not even an audio valve. Being VHF you should not need a long wire arial. More like about 1 meter. Might work if you are VERY close to the transmitter but otherwise it's just a nice paper weight.
Well, if I had seen this before buying the connectors, I would probably bought a new hose with fittings instead. At least I know what the investment will be.
I have a 1991 and the hard top is not popping up when clicking yellow button nor is there any noise being made can I manually release it to open or how do I fix I’d like to put the top down lol
Hello Guys, i also bought this kit and guess what, it does’´t functions eitjes. Although the amplifier does a good job… I connected a function generator to pin one an the soundtrack was nicely amplified. Question is, how could the input circuit be adapted to make this thing functionning? We could keep the tubes and transformers. Any suggestions ?
I would have to say that maybe if you hook two of these together, that you might get enough amplification to make it useful. Or you could try a really big antenna and a solid ground.
@@franklinyoutubehu2349 The frequency you are tuning would dictate the arial length. A long wire is great for SW but not VHF. The RF circuit simply does not have enough gain.
Is the implication that the energy consumed in attraction of matter towards to electrostatic field must be replenished? What I guess I’m asking is this: does a celestial body cease to have “gravity” if it’s electrostatic energy is dissipated and not replenished, or is that scenario not possible?
I am so thankful for this as acreatuve person. I was painting on the the floor with my canvas and my rabbit got curious of my paint, I whistled to signal Jim to stop and he ran across my canvas giving him blue feet. I Felt so bad because of it and put my art supplies outside my room, but I didn't know how.to clean them off without getting a kick in the face. When I found this video I cleaned a dust pan filled it hald way with water and got him walk over it. this video saved me so much stress. I was so scared he'd lick the paint and get sick 😭 thank you.
Honest opinion it's a pit.not impressed & I've never allowed any of our 10 rentals to ever get to that stage. Dirty walls ceilings kitchen filthy cabinets & countertop from the 50s .peeling & cracked paint. A number label on bedroom door? Caulking missing in bathtub & kit counter backsplash. It would never pass inspection just with the scratched unpainted wood within arms reach 😮
Nice experiment! Midea makes 2 Reversible Window Heat Pumps: MAW08HV1CWT (8k BTU) & MAW12HV1CWT (12k BTU). According to User Manual: (Heat mode) If the outside temperature is below 39°F, the machine will shut off and display ‘LO’. I got a one at Coscto in 2022 (summer 2024 they have the U-shaped unit which is NOT reversible), but Amazon lists both units in stock. I installed it in a guest bedroom, and mainly use cooling, but have tested the heating function, and it works fine (takes unit 5 min to switch between modes).
For $379 on amazon www.amazon.com/Midea-Conditioner-Ultra-Quiet-Operation-Energy-Saving/dp/B0CVVQWGH2, that isn't much or expensive than a normal air conditioner, but it doesn't have a defrost mode so it can't be used below 41 degrees. The other unit I see from Rovsun www.amazon.com/ROVSUN-Conditioner-Function-Installation-Assistant/dp/B0CYT39Z2V doesn't say if it doesn't work below 41 degrees and needs 240 voltage.
Just a note. The channel Tech Ingredients just did part 1 of a video on doing something like this. He hasn't announced when part 2 is coming out. Thanks for your video. My mind is buzzing. @@franklinthu
Hi there Franklin. The whole stooping down thing seems a bit cumbersome, especially for people with diminished mobility, might be a idea to be able to raise it up on an pull chord, so there is no stooping required. 👍😊
Thank you for the detailed video, I should be getting mine in two weeks. OKAY, I've been using the chair for two weeks and I love it. But the calf rollers don't reach my calf, or I can't adjust my posture enough for my lower legs to impact the calf rollers. The best I can do is push my calf muscles down (press) them but even then, I don't get the impact I wish I could get. Now, after saying this it is NOT a deal breaker, the chair is wonderful! I wonder if anyone else has noticed this?
@@franklinyoutubehu2349Waves will pass through each other after interfering and hit the charges, whether like or opposite, pushing them away from each other. They can never produce attractive force.
assuming all else is true, there are a billion ways to test the relation. other than the fact that calculus is just broken if it is not correct in the limit of small velocity. here is what you do, you calculate the time for a bowling ball to fall a rather small distance, and you so the timing with a wire that is ripped our of its socket or something if you want to Jerry rig it but still get an accurate measurement. so lets say you grab a large stone or a bowling ball or something like that and you simple time it, the air resistance over a short distance should be completely negligible. you can either film it with a decent frame rate with a well marked background, or drop it on some contraption that sends or stops some electrical signal that stops your clock, then you will have precise measures and the difference between 2 meters and 4 meters should be more than large enough for you tel decisively tell the difference. it should be pretty accurate as long as you get the timing rig right. if you simply get a good start and stop time accuracy and something heavy with a short falling distance, then you should be able to tell with close to certainty what the correct relation between height and velocity is. the terminal velocity of a bowling ball is something like 300 mph, depending on its size and weight ofc. but you are pretty safe if you are testing the difference between linear and a square.
