Helping you Fix anything so you can Save lots of Money and Impress your Friends and Family!
As a Do it Yourselfer, I appreciate the RU-vid community for being a great source of information. I started the Fixin It Channel to pay it forward and help others fix just about anything themselves.
With easy to follow videos and easy step by step instructions, you too will obtain the confidence to tackle any project.
I try to upload new videos every week, so make sure to SUBSCRIBE and hit the BELL button so you don't miss a single video.
Make sure to COMMENT and let me know what video topics you would like to see next. If my videos help you, please LIKE and SUBSCRIBE!
Well done 👍🏻I can't imagine life without a bidet shower, how do people get cleaned after the bathroom?!! I was shocked when I came to Europe and found no bidet shower at all bathrooms 🤧 I couldn't handle it, I came with a bidet water sprayer bottle just in case, until I got one in my place ASAP. Bidet showers must be all over the world and everywhere, keep up the good work 👍🏻
Thank you. I found it much easier to disconnect the light by pushing its tab and then unscrewing the bulb. I could not get enough torque to spin it out while it was still attached
You can try this if you don’t mind the black. Thanks for watching.😎 ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-OTjy-3kt0vU.htmlsi=pXn1IHbOUGGeGk_K
Hey, I have a question. Do I have to use the tint shop that they put on the paper or can I use the one near me? Also, what is the percentage they allow for the front side window and front windshield after the medical note?
You have to use the shops they list. % is not much but I would get darker after you get the medical exemption. I doubt a cop will give you a hard time with the exemption.
If the socket is melted, replace the wiring harness. However, buy the zevo 1157 red LED bulbs. The sonatas keep having the same electrical issue over and over. Replace it with the new LED bulbs and the problem goes away.
I can’t get my shaft released from the rack 3:44 any suggestions. It lose a can wiggle it it’ll come off but it like the shaft doesn’t have enough room to tap out help pls ?!?!
Don't bother with the code. Turn engine to "on" and hold down the volume/power button for 2 seconds and it resets, worked great on my 2011 Honda Odyssey Touring
I get that same indicator on my 2010 Escape. It goes away when I turn off my car but lately comes back on when driving for a bit. Still runs OK. Should I be concerned?
