I have manual car but have a automatic tft, is the connection the same?, I would like to test to see if its ever work without coding before buying manual cluster.
For anyone else having this problem, I had a 2013 s60 t6 that was burning about a quart every 2k miles. I used a product called 505 CRO by ATS and it reduced the amount of oil it burnt down to below half a quart every 5k miles. Absolutely recommend giving this product a try. You pour it directly into the crankcase, start the car and Rev it at about 2k rpm for 15 minutes, then change the oil. This stuff does an amazing job at breaking down the carbon deposits on the pistons and rings, letting them seal a bit better again. Also, don't replace the engine, that won't solve the problem. You need to replace the pistons and rings. The rings are the problem, and the new rings designed to solve this issue have a groove in them that fits into the new piston. They will not fit on the old pistons, even though the old pistons are not the problem. A used engine will most likely have the same issue and be a waste of money. Replacing pistons and rings should cost about $2000-3000. A bottle of the 505 CRO is $50. Your choice
I cant install it because something that pins inside hits inside something and connot connect it to the mirror. Can you show inside how it looks the pins mate?
Mine uses 0.5l every 100 miles now. Engine is loud and it is nowhere as smooth and quick as it was (V40 D4). I keep hoping someone will steal it, or somebody will smash in to me and it can be written off. Absolute bag of shit! Worst car I have owned.
Hi, Can you tell us how do you get the armrest out at first ? I have a bad contact with the cigarette lighter and can"t figure out how to take this out in order to access the contactor at the front without breaking it.
That is a critical problem about this part. It will not keep it from breaking again. I think the seat is too soft and when you go in and out, the bodyweight goes all over the seat panel. Maybe they could sell a stronger foam to fill the seat, so it would keep the body from weighing over the seat panel. AAAANNDDD someone could upload on THANGS the 3D stl file so we could print this part in ABS plastic. ALSO, MAYBE we will have to use some expanding foam to fill the outer side of the seat foam, so it could work in the way above.
Hello, do you have any idea why the steering wheel on the XC 60 2012 is quite hard at high speed and sometimes makes noises at low speed? I replaced the power steering fluid and there is no difference.