So much more sensible (and accurate, probably) than the strange diagrams lots of videos show! I had been using a bit of trigonometry to calculate the angle (Tan(angle)=(square root of (rake squared + splay squared))/height) which worked fine, but your method is definitely simpler! And you don't really need to know the angle - just use the gauge to set up the drill press.
Simple (in a good sense) but great approach for diyers - thank you, sir. Preparing to build sawhorse workbench and was going to make it with 10 degree legs. I'd say I'm quite close.
This is great. I'd like to see your drill press set up for drilling your holes in the seats. I've been looking a long time and there's nothing on you tube covering this.
Hi Bruce.... I just drill them manually by sighting down the drill and referencing off of a t-bevel gauge set to one side and a square set on the sight line. I use a bit and brace since it’s a slower process and veieasy to control. Check out Curtis Buchanan on RU-vid. Huge wealth of information and he demonstrates these steps very well ... plus he’s a great story teller and darn close to a National Treasure!
@@727williams Hi Alan. I'm drilling into the bottom of half round logs for benches and would like to get the angles symmetrical. I've tried the bevel gauge technique but it's pretty difficult on random shaped logs. I think I'll end up building some kind of a jig. I have some ideas, but I'm not entirely sure what it looks like yet. Thanks for your reply and suggestions.
I’ve been using a Rockler portable drill guide on live edge benches with excellent results. For half logs, which I’ve been going to try, I think I would use the same drill guide but make a jig out of flat dimensional lumber to go over the bottom of the log, bottom facing up, if you get my drift.
@@michaeldennis4860 I ended up building that jig and it works quite well but it's pretty fancy and cost me $400. lol. I was determined! The problem I'm having is for drastically different sizes, since I'm doing from 9" up to 20". It works great on the big stuff. If you'd like to see more let me know. I've never done a you tube video but I should at some point.
I kind of hurried through that early in the discussion when I had my paper pattern but basically drawn out a few simple lines on the seat bottom. I connect my points between the drilling point and where I want the leg to land and extend a line from those...then I sight down that and drill at the angle I’ve come up with. Once the lines are laid out on the bottom it’s easier to see the symmetry you created...hopefully this isn’t too confusing. Peter Galbert’s book has great information on this process and also Curtis Buchanan on RU-vid is outstanding.
It’s a genuine gift for those who don’t have access to chairmakers and their books. I think this is the best way to teach new makers. Thank you for this video Allan.
way2dusty I start my mixes in equal parts of the poly/oil/mineral spirits....after several coats I add a little more poly...it’s not very scientific but I still want to be able to still rub it out by hand. If it’s gumming up on me I just add a little mineral spirits. Most woods do great with 4-6 coats. Thanks