ACM SVD with all airsoftpro tuning components and with this set is an overkill. after 10 shots with 0.45 BBs i got 5.89 joule and 673.16 FPS just for fun: with 0.28 BBs i got 6.86 joule and 572.88 FPS yes, the distance is extremely good, somewhere on 110 meters with half hop up setting, but in Slovakia we have some areas where the joule limit is 3.2 - 3.3 they won't let me play with this monster :D
ALWAYS ALWAY ALWAYS PUT A DROP OF SILICONE "PELL OIL" (CROSMAN) ON THE TIP OF THE CO2 POWERLET BEFORE PUTTING IT IN ANY CO2 GUN!! IT PRESERVES THE GAS POT SEAL FROM DRYING OUT, DEFORMING AND CRACKING ! IDIOTS!
Why are they out of stock in Czech Republic? I would want one of these so badly Only the silver (and more expensive) one is for sale but that one looks kinda bad
I bought one of these about 13 year back and it's still going strong today. The only problem is the magazine outer skins shatter around the screw that holds them to the steel mag inside if you don't support them when filling with gas.
Jaksi mi tu nesedí jedna věc, zakoupil jsem u vás SET od TNT, ale jak je tam to ocelové T v čase 4:35, tak moje má uprostřed důlek, ale na videu je vybroušený ze strany na stranu. Dále jsem doporučeně k této zbrani zakoupil pružinu 140M, ale do zbraně nesedí, takže jí budu muset zkrátit. Jako poslední bych se chtěl zeptat jak nejlépe utěsnit zbraň, tak aby nikde neutíkal vzduch po výstřelu. Děkuji.
Pružina M140 ti ako nepasuje? Na dĺžku? Ak na dĺžku to nevadí to tam piestom a hlavou valca natlačíš Utesnit aby ti vzduch neunikal, zisti či valec tesní (maj ju k98 rozobratu ako bolo na videu, že hop up časť je odmontovana) natiahni k98 a drž palec na hlave valca, vystrel. Valec ti bude tesniť tak, že po vystrele piest sa pohne len trošku a budeš na prste cítiť tlak vzduchu vo valci Hop up musíš pretesnit, asi kúpiť od aspro hop up komoru a novú gumičku, mne tiež cez hop up uteká vzduch S 0.25g bbčkami a len pretesneným valcom mi to ide 1.7-1.9J
nevejde se na šířku, kupovaná pružina 130, kterou jsem měl v TNT KITU má průměr cca 0,9mm, doporučená pružina pro snowwolf kar98 140M, kterou jsem z airsoftpro koupil zvlášt má průměr 1cm@@sebastianskoluda657