Sure, once you install the batteries, it will automatically go into set up mode, w/ prompts for time, days, on and off water flow. Be sure and use Lithium Batteries as they will last a couple of years. Thank you for reaching out! Cheers
Hi, I have a Cartier Santos Carree Monocoque case and I'm trying to figure out if it's possible to fit in my ETA 2671 in there. Can I put the male/female stem also in a generic ETA or is this some special modification that will only work with the "Cal. 077"? (Since it's just a rebranded ETA 2671 anyway)
Hey Max , the new ETA will come with a stem. Provided it is male/female (sometimes not) , the crown will fit fine. Thank you for the question! You can reach me at mfosterjeweler ~dot ~com. Best Regards M
With some capacitor being placed faced down, I was wondering if the Panasonic engraving will be face up (visible when installed) or face down (hidden when installed) on the v137?
@@robocop8289 Thank you so much! I was wondering why it wasn’t holding a charge! There really isn’t much in the way of tutorials about this model. Thank you for your video!!!
@@XoMrToni Sure thing, I was really surprised that HATTORI didn't even have a PDF on this, so I pulled out my Canon Sure Shot and made this out of frustration!
Great vid! In addition to checking for hair, check to make sure the lube hasn't solidified. In my case, the lube used had solidified slightly around the gear that spins the brush, causing the shaft to bind on the hole it goes through. Scraped off the solidified white gunk on the shaft and the hole and back in business!
Could you please explain a little better the orientation of the contacts, particularly the V shaped end. Do the both go on top of the circuit board or below the circuit board? One above and one below? Is the engraved side up or down? I can't see any of this. The came in with out a capacitor. Thanks
Right, NO ONE has made an attempt to show this type of replacement, so thanks for at least trying. When you say place the "V" away from the coil, it looks like you are pointing toward the crown. Is that correct? Can you see any posts or connectors that the "V" is going into?
I know I had to hold the camera and shoot the video. I couldn't believe Hattori didn't have anything about this on the WWW! Not even a PDF. When I get another one in I'll do it "in studio", thanks for your comment
Thanks, we just need to make sure that the VA and it spread wide enough apart so that it makes contact. It was very helpful because I was confused after the battery popped out and I didn't know which way it went back in. Thanks a lot Gary Green