Este canal ha sido creado, para ayudar a todos aquellos gomosos de los sistemas que estén empezando o que ya tengan bastante tiempo en el campo de los Servicios Técnicos en Sistemas
hola buenas tardes, compa tengo una epson l355 y ya la arme pero al momento de encender la impresora el carro sale para un costado y queda bloqueado, cuenta con cabezal,tarjeta,flex nuevos pero no encuentro la solucion
Other than FULLY turning the bottom screw, which does nothing but either hug or push the cover away from the body, here are some instructions I hope you find helpful. Location of attachment points: BOTTOM: Measuring 1 centimeter from the bottom corner along the bottom edge on each side, you will find one plastic hook attached to the back case clipping onto the internal plastic frame. A very thin flat blade screwdriver should release it. Otherwise no other hooks or snags along the bottom. SIDES: This is where the real fun begins. Strangely the back cover has inset attachment points, instead of between the case edge and the screen. 4 U-hook anchor points located at: 1). Horizontally: 1.8cm in from the outside edge, Vertically: 7.8cm up from the bottom outside edge 2). Horizontally: 1.8cm in from the outside edge, Vertically: 14.4cm up from the bottom outside edge 3). Horizontally: 1.8cm in from the outside edge, Vertically: 19.5cm up from the bottom outside edge 4). Horizontally: 1.8cm in from the outside edge, Vertically: 28.8cm up from the bottom outside edge These are the MOST difficult to disengage. Simply running a guitar pick or screwdriver or slidey bar between the edge and screen doesn’t work. In the past, I’ve been too gentle on the edges and like a surgeon separated the screen glass from the screen digitizer ruining the entire PC. My suggestion is to stick a screwdriver or a block of something inside the stand hole, between the cover and the body to keep up the pressure on the back case as you go along. Since there is nothing to release along the visual edges, you have to pull the bottom, slide along the side, relax, pull, slide, relax, technique along the bottom and edges until something eventually gives. Hopefully, it won’t be your patience. Fingernails are sometimes the best weapon. TOP: There are 8 cover plastic nibs spaced evenly along the top edge, 4 to the left and right of the camera slide switch. You might try inserting a very thin guitar pick along that edge. I didn’t because I was too afraid of killing another PC again. Getting the plastic cover away may be tricky. There are no delicate cables to worry about. You might get a string of rubber coming out from between the side edges but you can lightly glue them back, I used a slight brush of Elmers rubber glue. This is the worst case I’ve ever seen for repairs. The attachment points are way too hard and certainly not made to easily open. I would never suggest this PC because the next repair guy might have to buy you a new one out of his own pocket. Good luck friend, you're going to need it. 😄😉
Les agradezco muchísimo por su video, me sirvió enormemente, me pareció muy fácil. Que Dios los bendiga por tan excelente labor y por querer ayudar a otros.
Porque no enciende ??? Le doy al boton de emcendido y no prende ... Y cuando le pongo el cargador igual no prenden los leds donde indica que esta cargando ....que sera ?.. sera el cargador que no sirve y esta muerta la bateria ??
