The front hubs can be changed so regular rotors can be used. I did it on my 97" Accord. You reuse your stock calipers. I used the 4 lug bolt 1998 Acura CL hubs, but that's only because I just bought rims for the car. I really wanted to change all four hubs to 5 lug bolt; more choices when it comes to aftermarket rims.
Il give that a shot, as far as i know the whole knuckle assembly has to be changed from a 1st gen odyssey to be able to run the 5 lug swap but maybe not haha, I appreciate it bro🫡
I gotchu bro, i got a new job and ive been working long hours but im adjusting to it finally so il have a video out soon. The accord is going to be the next one i upload, I appreciate your support🫡
So glad I found you doing this as I have a very similar table and I want to do this to mine and your video is very helpful, wow well done it looks great 😊
Good job on the rear windshield good luck on the passenger side, but keep up the build an the vids bro great content an can’t wait to see what’s coming in the future 👍
This video might be one of the most relatable I’ve seen on RU-vid.. That bad input shaft bearing and the damaged threads are common issues. Despite those problems, the rod bearings looked in decent condition, I doubt that engine was knocking. Solid foundation for a build. Great work on the motor and the video!
Thank you🫡. Towards the end i didnt even care about the small issues i just wanted to have a good base to work with and i think thats what we got haha. I agree tho i dont think it was hurt the bearings looked ok and the crank as well. Time to make her look pretty
Aye bro did your Honda ever pass emissions?? I use to work at Air Care back in the day as an equipment tech. Just curious what station you took your car to get tested