Can’t get it into neutral

your trucks clean as hell and if anyone has this problem and you need the truck to crank hold the key in start and slowly pull down the shifter into reverse and sometimes it will crank if switch is going bad

U skipped the only part of video I needed

So did it start up after you installed the new switch?

How do you take the plug off?

So your truck didn’t start even if you put it in neutral?

I have the same truck new battery and alternator .no power. And no crank all deid . any advice ? Thanks 👍

I just wanna know how you got the harness back on because I can’t get my harness to go back in

Very helpful.

Thanks dude. After spending many hours trying to figure out why my 05 Colorado won't start period, I've made it to the neutral safety switch myself. And with the clear help you just gave me in fixing to finish removing my neutral safety switch and repair it and fingers crossed it'll crank up!! Thanks for the info

Do you oír it on neutral or can be se on Parking

How tight did you torque the bolts?

Sure wish I could have seen you unplug the harness and plug back in other than that very good information thank you

Great video...thanks!

What's that ring behind the arm that you're adjusting toward the end of the video?

Thanks for the video. The wiring harness is a bit tricky. I have a video that explains: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-LRHJTwXu8lk.html

Thanks for the info and video. I have to replace it on my Yukon. Same issue.

Where is the output speed sensor at?

Is this the “shift position sensor”? I’m looking at buying an 05 Silverado single cab and the guy says it needs a “gear shift sensor”. Says if you throw it neutral it’ll go tf??🤔

Where is your drive train? I got under there and had about 1/2" to work and couldn't get to the bolts because the drive train runs right up against it on a 2002 GMC Envoy. Do-it-yourselfers beware!

only replacing its nothing

Why are you whispering??? Speak up

could this cause for my back up lights o not work on 02 avalanche

Cleanest 05 Sierra I've ever seen.

really very good video. good explain.

I ask because I'm throwing "p0706" but don't have any issues starting or maintaining driveability. It's described as "transaxle position range/circuit range sensor". I'm not sure if I need to change this post from your video or not. Thanks for trying.

hey buddy, very good video. did u throw any codes before u decided to change the safety switch?