could bad oxy sensor cause this also? My 350z was running perfectly - then sat during the lockdown and now this low Idle has happened. It seems the car is burning rich.
hey salvage, i just picked up a 07 g35 coupe on the cheap and liked you're videos. Do you still have yours? Any plans for more videos, i would definitely watch them!
Did you ever figure this out? I'm planning on pulling a cluster out of a salvaged sedan for my coupe. I'ma just try to keep track of the miles for when I get a newer, programmed cluster from Tanin Electronix
You have a bent lifter my 05 Infiniti G35 sedan have the same problem somebody put the wrong but sky City or oil in it or they left the engine running low on oil
I was a dealer mechanic for years and this has to be the most ridiculous car repair I have ever done. All this to replace a couple of dash light bulbs? Ridiculous! That said, it would help a lot if the people doing these videos would start off telling you WHAT is holding the stupid dash cluster in. After all, I took several things loose that are not necessary (and will be difficult to put back). The first (and biggest problem) is that each of these Infiniti models seem to be substantially different. I watched 10 of these videos and my 2008 G35X doesn't come apart like ANY of these. But the one thing these videos all have in common is that they ALL skip all the connectors you have to take loose AFTER you get the gauge cluster loose. (Hint: roll the windows up before you take the ignition switch connectors loose, after all you may never get the damn thing back together.) That said, my advice is, have a couple of lights out? DEAL WITH IT. This thing was not made to EVER come apart. IN CONTRAST, I can replace every dash bulb in my F-150 in less than an hour. This thing? I have 6 hours in it and it still isn't completely out. Um, did I mention that I stabbed myself in the hand with a screwdriver trying to take some of these connectors apart?
My rear axle nut was loose loose, just like yours🤔 just replaced the hub assembly with bearings yesterday. I hear these rear axle nuts get loose on the Gs or something. Saw it in forums.
Should of spent money on new lifters… sounds like shit man.. I can hear the engine noise over your exhaust… and the camera is sitting on the ground behind the tailpipe… that’s horrible…
Yes. the testpipe design does not allow the down stream o2 sensors to enter all the way into the pipes, tricking them into thinking that there is less gasses passing through the system as to what a catalytic converter would do.
I added the nwp 75mm throttle body and I’m having the same issue and the code I got was pertaining to the throttle/pedal switch sensor in the gas peddle
