Welcome to my You tube Channel. I'm an Electrician and an Electrical Apprenticeship Professor in Toronto, Canada who loves all things to do with Motor Control, Process Control, Arduino, PLC's, Electronics and incorporating Tech in the classroom. If you have any requests for new video ideas please comment below.
Disclaimer: This channel may contain technical inaccuracies and/or errors. I try my best to ensure the accuracy of the information provided, but do not warrant or guarantee the accuracy, reliability or legality of any of the information contained herein. Pete Vree is not responsible for, and will not be liable to you or anyone else, for any damages whatsoever, including any indirect, special, incidental or consequential damages from the use of information given in these videos. As always, electrical work should be performed by qualified individuals. Please consult a Licensed Electrician in your area for any electrical work you plan to do.
Good morning engineer, I have this speed control, this is the KBIC-120 model, the problem is that it burned out, the motor model is Baldor CD3475, it has a switch that reverses the rotation forwards or backwards, any guide on how to connect it to this speed control, thanks for your time
Hi Pete, what software do you use to record the videos? I am recording video as well, but the software I use only display one Camera. Yours has multiple. What is the name please?
If for some reason i lost my youtube account, and made a new one you would be the first channel i would subscribe to again, i really appreciate you sharing your knowledge sir!
What is screwing me up is the #5 wire, shouldn't it go to something separate that closes the holding contact? I think I just figured it out lol. Ok so when the coil is energized it closes not only L1 L2 L3, but also the holding contact?
The way he explained it the wiring in the video for the high voltage is wrong then you should probably relay that to everyone so they don't get confused other than that really good video
Sir i have a golf vehicle when i press pedal single time it can not move so i press pedal many time then it move and the smoothely run but the only problem is that its starting torque is very low because batteries are fully charged i check input voltage of motor 48 volt dc exact i want to increase motor starting torque what you suggest please reply its humble request
I'm a residential electrician which is nothing compared to this and slowly I started accepting my truth at class that PLC requires more brain than what I have but you're videos are giving me hope, you're way of explaining is making sense to me finally, TY! 2 months away from graduating
your tutorial is useful but i needed idea on how to set up the usb 4750 using driver , i have downloaded and installed the driver and SDK of DAQNavi , but the driver is not being recognized by device manager , pls help
I have a small motor like this but its not wired this way where the windings have a long jump line. The two windings are connected together but kept separate by the brush and armature. I think its way less confusing to be wired that way since the way its wired on the diagram is the way its wired irl. Whereas in the vid that jumper wire can cause some confusion.
