Pelistriimejä ja videoita useimmiten hyvin ala-arvoisella ja kyseenalaisella huumorilla, huonolla kielenkäytöllä sekä epämääräisillä vierailla höystettynä. Mukana myös kotikutoista musiikkia sekä vierailevien artistien tuotoksia.
Identiteettikriisin vuoksi englanninkieliset striimit ja videot jatkossa @rAIVOkoneENG kanavalla. Käy tilaamassa, jos haluat katsella myös lontooksi vedetyt pätkät
@@cheebacabruh4202 Tais olla hämmästys siitä, ku katoin tutorialeja ja yks striimaaja joutu "vähän" enemmän ruuvaamaan, että sai osuman 😃 Taitaa olla realismin suhteen meillä eri setupit
AV1 is now finally working in my case! I haven't done anything else except updated OBS. AV1 started working a couple days ago and the last time I tried it without luck was months earlier.
still have same problem till this day, i use RTX 4060 streaming 1080p 10k bitrate, it sad coz i chose RTX for AV1, searching how to fix that its like rabbit hole, no solution
I actually tried AV1 today when streaming and it worked????!!!!! Nearly 4 hours and didn´t disconnect. I don´t think I have done anything special except updated OBS... 🤷♂ I don´t have clue why it works now
Varmaan paras olisi, että nauhoittelisi OBS:llä koko setin samalla kun striimaa. Itsellä ei moiseen tilaa, niin pokerina vaan nauhoittaa RU-vidsta striimatusta pätkästä OBS:lla klipin/klippejä mitä haluaa käyttää. Laatuhan tällä tapaa kyllä kärsii. Sitten editointisoftaan klippi/klipit. Itse käytellyt editoimiseen DaVincia, taitaa olla paras ilmainen softa. Siellä joutuu sitten puljailemaan asetuksia yms. että saa oikeat resoluutiot. DaVinciin löytyy kyllä melkoisesti tuubista opetusvideoita. Näin lyhyesti.
Voidaan kattoo pelit kyllä! Jos insta löytyy, ni pistä kanavan Insta tilaukseen, voin sieltä kautta privana viestitellä, ku oltais pelejä suunnittelemassa
Same problem here. It's not network or ISP, I believe it's either OBS support for AV1 encoder, RU-vid ingest, or Nvidia encoder at fault. I was using an Arc A770 for QSync AV1 streaming at 1440p60 to RU-vid. It worked flawlessly, until I hit a bandwidth limit of around 28Mbps to YT while also streaming to Twitch at 8Mbps on a 50Mbps upload. As long as I stayed around 28Mbps for YT, there were no problems at all. I replaced the Arc GPU with a 4070Ti a couple of months ago. When streaming to YT using NVENC AV1 in OBS at 1440p60, at some random point during the first 30 minutes at even 16Mbps, YT upload speed will drop under 200Kbps and never recover. This is replicable and happens on every stream attempt in NVENC AV1 to YT, at seemingly any upload speed between 12-28Mbps. Swapping to NVENC HEVC at 28Mbps to YT and H264 to Twitch at 8Mbps and there are no problems to report. No dropped network frames, everything is rock-solid. Looks like I'm stuck on HEVC for now, which is a shame given many of us have forked out for NVENC AV1 to YT. Replacing the Arc GPU with the Nvidia one coincided with the OBS 30 update, so I don't know if it's a software or hardware encoder issue. I've seen this issue enough times on the OBS forums and Reddit to know for sure it is not ISP or network-related as there are no problems when not using AV1 to YT in OBS.
Did you ever figure out a solution? I am having the same exact issue when i multi stream and use AV1 on RU-vid. Twitch stays flawless the entire time but RU-vid shits the bed every single time.
Did a test stream two days ago with AV1 and the bitrate dropped immediately. I tried another cat6 network cable, but that didn't do anything. So still clueless.
@@dylanisadragon Yeah, same here... It's also strange that streaming with NVENC works flawlessy. HEVC drops some frames, but the stream never dies like it does with AV1. Maybe it has something to do with the rtmp server... What I've read, HEVC and AV1 uses the same server... but who knows.
i have the same issue. anyone knows a fix ? i can use HEVC fine but av1 kills the connection . only fix i tried is to set the bit rate frequency match obs and system .... but for me didnt worked
All good, still running! No issues so far. I'm using the 450w 12vhpwr cable that came with the Thermaltake PSU. The cable is really flexy out of the box so the notorius bend wasn't an issue.
@@rAIVOkone thanks for the quick answer :) I get a 4080 tomorrow and already have a bequiet pure power 12 850 the 12vhpwr cable is really hard to bend, so i'am a bit sceptical if it will work in my h5 flow..
@@rAIVOkone I have it yes and it fits surprisingly well, still 3-4 cm room to the front and just enough space to the side.Had to bend the power cable 1cm sooner than bequiet advised but for now it works.
omg dude I have the EXACT SAME ISSUE. This is so frustrating it was working just fine until ~ 10 days ago and now I can't stream at all with AV1. WTAF?
Yeah, this weird and frustrating. Some say it has something to do with your isp, but I doubt it. I also get some weird dropped frames when streaming with HEVC, but the stream is able to recover. With NVENC, no problems at all. I haven't been able to stream with AV1 more than ~10 minutes at all from the beginning. 😵
Do you think the Rog Strix 4090 would fit even though it's about an inch wider than this one? Askin since i have the regular meshify 2 case and want to buy a 4090 strix to try and match the black w/rgb design i got goin on. Upgrading from an Evga ftw3 ultra 3080ti.
Do you mean the length of the card? Gigagbyte 4090 Windforce and Asus Rog Strix 4090 should pretty much have the same width and height. Asus is a bit longer though (Gigabyte 331mm and Asus 357,6mm). Lenghtwise, Meshify 2 can house a 445mm long GPU with the original fans at the front and Meshify 2 Compact only a 341mm GPU with the same setup. So you should have more than enough space at the front (87,4mm) compared to my setup (only 10mm) :D Meshify 2 is also 30mm wider than Meshify 2 Compact, so clearance with the 12VHPWR cable shouldn´t be an issue.
