If I remember right I had it set at 1080p resolution, the actual settings were set as Ultra throughout. One thing to note is that this was a much earlier build of Pinball FX too.
Kien can you tell me, when i put on the info intertainmant battery on the screen, always the radio goes on. For me, good phev.Or electric car when you plugged in. Also Nice when you drive the Mountain, battery pack wil be loaded
Thank you for the effort to transfer and upload. I have a 2015 Gen 1 Volt and thought I'd seen everything on them but while I likely know it all, having this content I hadn't seen and being preserved is cool. (Edit: having watched the whole this there was plenty cool explanation and commentary from presenter)
Off course, good car. 2 thing todo, the 12v battery change and the cooling water battery pack change. A lot off people forget that to do, so then you can wait for problems
My old boss had one of these when it first came out. I used it a few times back in the day and it amazed me. I was working with an old IBM XT at the time!
Can someone tell me the voltage output for the power supply's connectors?? Those: ibb.co/nmqRZ0Z ibb.co/QnzDcrY Please, i can't get the information anywhere!! i've been looking for years
How are you able to have only one user control the claw at a time? I have my claw machine connected to a raspberry pi and would like to make it public but at the moment anyone who can view the webpage can control the machine. thanks for any help you can give!
How it was controlled was not live where the user had the stream up and then pressed buttons to move it. But instead was that they entered an approximate location using two sliders on the website. The claw ran code which ran through each request one by one. Not the best solution but was quick to whip up in the time I had.
That was a right pain to get going. Involved writing a new disk in my Windows 98 Computer and plugging it in, If you'd like I can possibly make and post one out to you.
Hey Ryan, Thanks for sharing this nice video! Question: how did you open up the keyboard to replace the cable? I removed the screws, but it still doesn't open. I dont want to force it too much, so have to figure out how to do that. If you can give me some instructions, it would be nice. Thanks!