If you are replacing spray nozzles, these R-VANs don't fully come into their own until you have replaced the entire set. Even a single spray nozzle can suck up much of your water pressure, leaving the rotaries underpowered. Once you've replaced all of your nozzles, these perform great, with very long throw distances if you need them. And, as everyone points out, they look cool in action.
I have this lawn mower, it cuts too low and can't be adjusted. The highest setting, 6 , is so so low, lower than the lowest setting on other lawn mowers, makes no sense. A lawn mower should adjust to 5 inches, this is barely 2.9
I really appreciated 1:20 where you showed a portion of your setup laying in the grass. I'm an old Colorado Hippie, and seeing the three different sized emitters side by side SUDDENLY made sense to me. Bravo!! Some of the "vitamins" I took as a pup seem to have made my easily confused... baffled as I stare out at ALL extra parts and thingys that looked like they'd fit SOME darned place.
I was running this saw for about 2 hours at about a 30-50% duty cycle ru-vid.comUgkxfQm1wmg0ItKDLavxj1nXtQY9HP7EF504 and it did a great job. I used the lever for the built in sharpener to clear chip buildup out more than to actually sharpen the chain. It managed to cut some hardwood stumps much larger than it's size without bothering the neighbors with hours of 2 stroke noise.
Works great! ru-vid.comUgkxprGGPRQoChQaA8u58dt7miEpxQBKiWeJ More difficult with longer grass, though, but I was expecting that. I have a small back yard, it seemed like overkill to buy a lawnmower with an engine. This is easy to carry in and out of the basement through the bulkhead. Very sharp (be careful). At the back of the mower are little wheels, which I use when pulling the mower backwards, so it's easy to readjust direction. I'm including a photo which shows the before and after for my lawn when it was at its longest. For long grass like that you really have to put some muscle into it, and I needed to go into a new section of grass with some momentum, but when the grass is only an inch or two higher than regular cut height it's quite easy. The lawn is still patchy and full of weeds, but at least it's a good height! A step in the right direction.
Hi I have a lavor 160 WPS and something seems to have gone wrong with its got a burning smell coming out of it and a little black liquid also come out ,now machine has no pressure,how can u resolve this
Dead grass and dirt and weeds can form a thick layer of dead material between the roots of the grass and the top of hte lawn. That chokes the grass and keeps water and nutrients from getting to the roots. Tearing that crap up once a year and than maybe seeding some fresh grass on top gets you a great healthy lawn. But it should probably be done in the spring to let the grass have time to recover.
Greetings, I installed a lot of these sprinklers and I almost had a problem, where one of the sprinklers stopped turning. Do you know, perhaps, what is the cause?
I've used soaker hoses for year but I like this Rain Bird drip arrangement. The price of soaker hoses has gone through the ceiling. I like this system because you can direct the water right to the plant. I might switch over to this system.
The 'Cancel Watering' is for when it is raining. You press 'cancel watering' and repeated presses of the cancel button (or using the right hand up and down buttons) will set the number of hours that the auto functionality will be delayed.
