this lcd screen is attatched to smth i dont see on my lcd screen. what is this blue thing with less pins than the lcd itself? can anybody help me out? im new xD
Solution for Arduino IDE users: turn the version of the esp32 board library from to 3.0.2 and it will solve the issue of constantly rebooting in the terminal. 21 jul 2024
Good day great work A question how do you integrate bno055 imu in the linorobot2_hardware? Do you make your own library or use some sources on that ? hope you notice me
Anyone know the value of the capacitor labeled “C3”? Although I don’t think it’s critical by any means, the servo tester I bought had this missing and I’d like to replace it.
I don’t think you understand what’s happening, the problem is GRBL is configured to uno pin map, by changing the bit numbers you are just re-assigning the pin map to the nano
@@cutedogohisnameisisaiah3712 I comment it without testing it , did same and now it's working. No, instead the pin wiring of step and direction is swapped on nano shield and pin of nano and uno are same so he just swapped it in software. This nano shield are designed with lots of mistakes like the common pin for step resolution is vcc but in nano shield it's gnd.
i seen so many of your videos and tried not to make comments as lets face it im sure youve herd enuf oh what i was thinking but this video was a life sver thanks sooooo much
1:55 why you cut your video. And how you open this tiny window in right corner. And how you het it from? To open tiny window in the right side from arduino ide window?