RoboCircuits is an Electronics Learning Page. Here you can learn cool projects for your own interests or school/college submissions. Here one can learn programming basics and advanced programming projects.
We especially use Arduino, and ESP and work on Drones * Like and share videos * Subscribe to the channel * Stay connected by pressing the bell icon
Get a free trial of Altium Designer with 365 and 25% off your purchase: www.altium.com/yt/robocircuits Free search engine for the best quality components from Octopart: www.octopart.com
Don't show full terminal did u forget It converts to address at least Google maps doesn't have that mouth data on ur place but that is accurate by 4 meters so it shows were u were in ur place just warning u be careful
@@RoboCircuits yes there are > but if someone not give a movement inside room within the time value set < PIR output goes Off> same with IR sensor...flickering trigger, as hands many times goes out of range of IR front ..>> we need a backup source to continue getting ON signal/supply to avoid interruption in output load.( i am trying some circuits presently)
you'll need a computer running all the time it could be as small and cheap as an old dell wyse and you can use tailscale with its subnet router to access the site
Two questions : 1. I assume we need to upload the code on both devices. Didnt find a specific mention of it in the video. 2. While uploading I am getting an error in the code line Mcu.begin(HELTEC_BOARD,SLOW_CLK_TPYE); Not used: C:\Program Files\WindowsApps\ArduinoLLC.ArduinoIDE_1.8.57.0_x86__mdqgnx93n4wtt\libraries\WiFi exit status 1 'HELTEC_BOARD' was not declared in this scope Appreciate if you can provide a solution. About the projects the one I would like is to use Blynk together with Lora for monitoring remote tank levels. Please develop one.
@@RoboCircuits Thanks Prasanth, couldn't find a board with the name "lora 32(V2)" there are "Heltec Wifi LoRa 32" and "Heltec wifi LoRa 32(V2). I tried both and it ends up with the the same error message. Mine is a V3 version whereas I believe the module used by you is V2, Could be this be the reason?
Get 5 of them, Set them up to send a Distress signal from a key fob. Hide 3 of them in cans and spread them out to where you can send a signal from your fob to soda can 1 ( with esp32 with battery inside ) and make Can 1 relay/repeat the alert to can 2 which will relay it to can 3 and then finally to your last ESP modules Display!. This would be useful for my friend who is an undercover detective. If you put batteries in them they could scatter cans at a site to relay the data back and forth, and if an undercover detective was in trouble, then they could press a button on the keyfob on their keychain, and that would trigger a message for you to repeat through the LORA eps32's scattered between you and them for you to get out of the Van and come save them Fob------------CAN1------------ 2-----------------3- ----------------4 ------------ ESP Display Alert!!!!!
Hi mate , i am really interested in this project . can you share including the file project please ? that will be appreciated . i promise to print with your logo
