If you are going to do one thing to a 240Z, (ok 2 things actually) bump the compression ratio to about 10:1, and put some 40mm sidedrafts on it (Dellorto>Weber) it makes for a punchy road car with much better throttle response that the Hitachi/SUs, and sounds wonderful.
Es una idea genial, lo aplicaré en mi carro. Me encanto la música quiero saber por favor el nombre de la canción. Gracias por mantener vivo al grandioso ZZZZZZZZ
@MOONFOG. Your welcome.Mix the correct ratio for the epoxy. Don't overload each coat. Medium wet to wet. Let the first coat flash enough so it's not sticky. Should be dull looking. Then put your second coat on. Wait 24 hours before you sand. Use a DA with an interface softpad. 120 grit works great. Blow and clean your surface. You can take a long block to check for low spots. Then put your bondo down. Epoxy will cover light oxidation. If you have any rusty areas behind the panels,you can use Por 15 rust encapsulator paint.Put it on with a brush. Don't get any on you. Won't come off for 2 weeks. Not joking. You can clean up with lacquer thinner before it dries. P.s Change your mask filters every week. Keep your mask in a sealed plastic bag after each use. Not around your neck. Filters only good for 40 continuous hours after that not good anymore. Don't get sick like me 3 times in 40 years.Long sleeve t-shirt recommended. Paint will travel through your skin into your liver. Just a warning. Keep up the good work.😁
Lol 😂 you should subscribe for the follow up videos on this truck it has been quite of a process this truck used to be red when we got it with a flat 6 cylinder engine and we swapped it to a v8 with ac..