Please help. I jumped F1 but my mixer is still having this error where it says “connecting” after a few seconds of use and then doesn’t allow me back onto the webpage.😊
For those of you who are wondering I solved it. You need to make sure F1 is properly Bridged together otherwise the mixer won’t run properly. If you are soldering make sure you put a decent amount of solder so that there is no voltage loss. My mixer hasn’t crashed of yet.
It worked I was very careful. My issue was the mixer lost connection and would not boot. I tried factory reset and it just hung on the blinking light. After I soldered that fuse it booted right up and is factory reset now. Question is that jumper only needed for the factory reset? If it falls off after will it hang up again? Also thank you so much for this, you saved a gig for us today! You rock friend thank you!!
@@kankantandikaigorotan1496 Mine doesn't blink the green LEDs or light up the WiFi/power LED, but it connects and enters the system normally and the commands: phanton power and gain don't work.
Like some others in the comments, I thought it wouldn't go far, as I tried many other possibilities, but.. THIS ONE was the only solution that actually worked! I was already scared, thinking it was going to need reballing. I can't thank you enough, my nobleman.
This really helped me last Thursday. Thanks man. If you're having the same issue don't hesitate to try the jumper it will work. I did this on the 1st August 2024
Thank you very much! At first, I was skeptical that it would work. But I did as some comments reported, I just heated the component with a heat gun and so far the table is working correctly! Thanks!
Congratulations on sharing yet another top piece of knowledge, saved. I did it and it solved the problem. May God continue to bless you always. By Brazil
My UI24 quit working 4hrs before a gig, this video saved my life. The fuse was not blown and had continuity but I still did the jumper and after blue light was back. Many blessings to you my friend 🙌🏾
Thanks for information! I got a different issue. On boot the mixer loses the previous preset and all parameters values are zero. Only the wifi and ethernet functions work maintaining the values of last time. Thanks for your help!