Hello Ahad Baig, The references you give in this video are absolutely wrong. There are other videos similar to yours that also contain erroneous data. You did not visit any Wadi Sal, what you visited was the Wadi Qada'ah, a tributary of the Wadi Al Bih. After traveling 8 km along the dirt track that follows the course of the Wadi Qada'ah, and before reaching the village of Dhanab, you took a detour to the right and went up the dirt track that goes to the village of Silay Al Khatami, which is at the top of the mountain. Currently, vehicle passage through that last stretch of dirt track is reserved exclusively for residents of that village. Please, I would appreciate it if you would review this data, and correct the title and references of your video, since it confuses those who see it, and is contributing to the spread of erroneous data. If you need more details, I can gladly provide them. Thank you so much
Hey , so my LCI headlights have been blacked out (from previous owner) and for the most part I like the look but the eyebrow that sits on top is also blacked out unlike your video and I really dont like that , any tips how I can return it to normal?
Do you have any experience in changing out the Halos with like 3/4 dtm rings for the LCI models? Theyre more common to do on the Pre LCI, rarely see them on the LCI models.
I think you broken 2 plastic clibs by pulling the front grill like this ,Because there are 2 more clibs down right and left,, that 2 clibs you can insert screwdriver (-) and rotate 1/4 time the clips till it match the square openings then you can pullout that grill , now you need to get new ones , thanks for the video
Just as a tip, they sell Y9 type H4 proyectors, they are plug and play, dont really need any special installation. You just put them like a normal bulb. and they give the same result but way less complicated
With these Bi-LED projectors, since they have fans, do you seal the stock dust caps so dirt and water won't enter the headlight or you just leave it open for ventilation? Thanks.
Do you think you can show a video of the headlights on , I was wondering how the lights look on at day/night to see if they are bright enough or not so I can buy aftermarket rings , this video was more than a year ago so who knows if you’ll see this comment but I’d appreciate it a lot man thanks in advance
hi, do you know if there is a lever for switching the lens for driving on different sides of the road? like from UK (left side of the road) to normal right side of the road. thanks
@@sesshoumarunagyur maintain it well by keeping it clean, ive even use a DA to polish it, dont slack off on the edges always wrap around My vid isn't the best and definitely learned alot since then, if ur worried about a section get a piece of scrap and test it to see how ud go about
@@sesshoumarunagyur rear bumper definitely should do inlay around trunk Front bumper the whole inner bit at the bottom should be its own piece and Inner corner of headlights Other than that its a super easy car to wrap
@@sesshoumarunagyur use masking tape to protect adjacent. Panels, and avoid cutting on the body just scoring the vinyl and tearing it is usually enough
Yea you can either replace the bulb that lights it up with a white led Or there are tons of kits on ebay that sells complete light up led halos, on prelci the best way to do it is completely remove the low beam one and mount new one to the cover of the projector And just paint the hibeam halo and mount new on top of that using fishing wire and double sided tape Pre lci lights are waaaaay easier to open , 230F at 10 mins in an oven is enough to open the lens
Can you show me where the angle eye bulb is located so I can replace it? There’s no videos online that specifically tells you how to change lci angel eye bulbs
@@havhout3707 it's hard to convey on video , especially in a lit up city, ther pictures in the end show the difference, look at the yellow building on the right