- predaj& prenájom profesionálnych laserových systémov (plnofarebné i jednofarebné) zn. KVANT s obsluhou s výkonom 2 -- 30 W . / Sell & Rental - programovanie lasershow /2D-3D/ programming show - laserová reklama / Laser Advertising - laserové mapovanie / Laser Mapping - komplexná realizácia Laser Show.
V prípade akýchkoľvek otázok nás neváhajte kontaktovať. / For any question feel free to contact me. e-mail: miroxx@miroxx.sk, miroxx@miroxx.eu Tel.: /+421/ 904 887 226 - Miroslav Marhefka (kontaktná osoba) , ĽUBICA 2014-2021
Is there a way to simply flatten the vertical access so that your Lazers is doing everything horizontally only. I’ve seen this guy that did it using quick show, but did not explain how he did it and it was literally a push-up a button is laser was just going through the auto programs, but stopped, going up and down. It completely completely flattened the axis. Which is super helpful in a club atmosphere.
you want to show off the differences between the two and intentionally only upload the worst possible quality video. re-upload in 4k and bring the Kavant back in focus and well see an entirely different and accurate comparison.
Hi, nice laser show, can you tell me what scan speed you set it to with what angle degree please?, I'm trying to figure out what the best setting is without damaging the laser.
I need something capable of a display like the one in the clip below at mark 1:05+ (I.E., area span/distance is minimal) for an ad spot. Would that require renting something as advanced as the CM 2000 (or competitor equivalents) or are there lesser machines capable of achieving the same effect? I’m aware of the purchase cost for these guys and it’s out of budget and would be a waste to have it laying around after. I’ll need to get someone who knows what they’re doing obviously to operate it, but I’d like to know going in the equipment requirements. If you have the time to answer, thank you. Please excuse the hilariously dated clip, BTW. ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-RUm66iRkqHo.html
Hello. Tell me please. For newbies. Is it possible that at a laserworld company, lasers of different lines can work as a master slave. I have cs-1000rgb and ds-1000 rgb ??? Thank.