The worst machine that anyone can purchase especially if it comes with that piece of sh*t Courage engine. I have more Cub Cadet in my repair shop than any other brand. Don't buy this make it's a PIECE OF SH*T !!!!!!
I have a 99 500 cat and it gets gas when it wants to when I pull the little primer thing no gas is coming out of don’t run etc I feel like buying a new car off of eBay offbrand one
Get a pipe or steel tube that fits over the bolt and hold it a few inches on the bolt and a few inches off the bolt. Stick the pointed air chisel into the pipe. Use the pipe to keep the chisel point on the bolt
Very informative video lawn mower repair video. I watched a lot of repair video on your channel and they are very helpful. I'm wondering whether you are up for a collaboration or not. Hipa supplies parts for small engines and maybe we would work together to help more people in the community. hipastore
Mine battery in my zero turn came from auto zone in 2020 still going strong when it comes time for another one ill get the same one. Its says will crank up to 35 hp
I got lights and spark but no electric start. All fuses look good and also has a new starter solenoid. No clicking or anything at all when I press the start button. What could be the issue?
It's probably a bad starter or starter switch if you don't hear any clicking. You can try putting 12v directly to the starter with jumper cables and see if it turns over that way. If not it's probably a bad starter.
When I was a youngster, way back in the early '60's, I would stay on a farm in Penn Dutch country for 2 weeks during the summer. The farmer had 2 tractors, an Allis Chalmers (same model as in the video) and a John Deere. The Allis Chalmers was used for most of the farming that was done. I always rode shotgun sitting on the toolbox on the left fender and I held on for dear life. My job was 'go-fer' where I would run back to the barn or house when needed; if we ran out of mint tea then I had to 'go-fer' a fresh jugful. Thanks for posting this, it brought back fond memories of me riding on the 'tool box' of the old Allis Chalmers in the hot summer sun in Pennsylvania!
It should be right at the top of the marks at the tip. If its just a little over thats ok. Make sure the machine is sitting level when you check it too. A little to one side or the other can make a big difference on the stick.
A great way to save those rubber wheel center caps is warm it up with a heat gun to remove and replace when they get old and hard. You can use a propane torch but they can easily burn the cap. Great video thank you for sharing. LOL I see later in the video you know this trick.