The dynamat is used for vibration dampening. You want sound proofing foam mats. a car chasis and all of its panels vibrate and resonate to loud audio. also the exhaust on for example muscle cars cause chasis vibration (drone). this does not itself damped outside sounds, just the resonance of soundwaves in the door panels. the music stays loud, the chasis stops droning. sound dampening on the other hand muffles any sound wave. therefor, look for sound dampening material, not automotive vibration dampeners like dynamat.
The design is extremely restrictive and unlikely to work. The adverse pressure gradient will almost certainly choke the flow. Suggest you do some research on proper duct design.
I understood the CMD and how to paste the commands. I did not understand how these commands are inserted into the RU-vid side so that they effect throttling Thanks I know I am being throttled at this time
I was trying to discharge my GoPro batteries using this and I was getting the check port message. After watching your video, I thought maybe it gave that error because the voltage was too high, and yep, I went into the batt meter and it reported 4.36V. I put in a slightly discharged battery, and it worked fine. I wish there was some way to override that. Sometimes I need to discharge my GoPro batteries when I end up not needing them. Storage and discharge give this error.
This was a nice video, easy to understand, already learned about the basics in solidworks software years ago, so this video was the best one to help me learn basics in FreeCAD
I've got the ZD620 that I use for work. I didn't want to ship it out for repair. It was intermittently printing only half of the label. I cleaned some buildup from around the head and rollers, and snapped the head out from one side, and put it back in. It works great now! Thanks for the tips!
I can't figure out what's going wrong. I know I'm picking up IR light. I can see the signal from my remote. However, I have had no luck using an IR flashlight. If I point it directly at the camera, it picks up light coming off the LED, but only that point. I can not light up a space at all. Any thoughts?
reflected IR light falls off at a different wavelength. You probably need a brighter IR light, or use a barrier filter that blocks visible light on a regular flash light and if it has any IR wavelengths in it the flashlight it'll push through the visible barrier. You just need to make sure it doesn't block IR light as well.
I have been developing this solution to eliminate having to worry about that exact problem. Forget weighing and guessing if you have enough, and use every last bit of filament........ ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-pTs_UAhygUA.html
I appreciate the help! Been reinstalling drivers, and the only way I could get it to print was to hold the one side down while printing. This seems to fixed it for now. Thanks again!
Good idea. Just recently broke my original dolly strap. Just a heads up I have broke those cheap straps u welded on also carrying the same load. Needs to be a fatter strap rated for more weight.
Friend ! Watch my video on GitUP Git2 how I converted it into a night vision camera! I will be grateful if you write a comment under my video ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-lkW1BiLiyqM.html
thanks so much for this. Just being able to see how to open up the Nova was a big help, since their website says the skirt can't be taken off. Your other comments are great too. Thanks.