Yeah it’s the fan that came with the place when I got it, should replace it eventually. It makes a creaking sound but only when the motor is on (so sound stops even though it continues spinning for a bit after motor is off). You think it’s the bearings that are to blame? I like to be able to turn it on/off while I’m away to get some air circulating to even out temperature.
Hi! Could You check how much energy this LED-s takes when they're in standby mode (connected to WiFi)? I consider to buy them and connect to powerbank, and I want to count how long will this last without charging :)
not sure how to check that but I have it plugged into an old iphone power adapter, like one of the old underpowered USB-A ones (5.0V, 1.0A). Label on the Dots cable says "Constant Voltage 5Vdc, 1.5A max." hope it helps!
@@alphareview You could use smart plug with usage monitor or special plug meter. But now I'm thinking that this devices perhaps won't show small wattage, below 1W. Thanks for info about power usage when LEDs are on. I'm looking for power consumption in idle - to know how long they will be in steady mode connected to powerbank.
pro is more expensive and it didn’t have any features that the K2 version 2 didn’t already have that I wanted to use. What features specifically make you consider the pro?
I had a K6 and the main thing it was missing was USB pass through. It works fine in cable mode but if the battery was fully drained it would sometimes take up to 10 minutes for it to charge before it could even connect via USB. Also with no USB passthrough it couldn't access any bios settings on startup. I wish I knew more specifics but I did confirm with keychron that it was a software limitation and that the pro series doesnt have this issue. Oh and I wanted to see what lubed switches and the silicone bottom are all about. I figured that alone was worth the extra $10!
do anyone see monitor flickering or ghosting when pair with macos like mac m1, m2 run ventura? before i have there issue with U3023E and i will receive this monitor after few day more.
The fan speed controller in this video controls the fan, the dimmer switch installed next to it (Leviton DH6HD-1BZ) controls the light in the fan. To my knowledge there isn’t currently a HomeKit fan speed controller with integrated light dimmer in a 1-gang configuration so you’ll need a 2-gang for the 2 separate devices.
Hi i have just purchased this monitor and I wanted to connect my sound Bar to this via an optical cable. Is this possible so that all audio from my ps5 and laptop will come out through my soundbar?
Always check for power using an electrical tester before touching any wire, you could have turned off the wrong breaker by mistake. That's 240v which can kill you under the right conditions. This is a nice unit and I'm trying to install one now but still have electrical power in the wires even after turning off what is supposed to be the right breaker.
@@djunirasasmita4783 I didn't find sound in setting, it seems the soundbar can not be recognized in my mac mini (M2 chip), what's your computer, macbook? Plus, in the dell web, 521a supports mac and windows, the 522a only supports windows
can you help me? can i factory reset this keyboard? i already try all backlight mode and suddenly after that, it doen't already working, whenever i try to type any letter, no one appear in my screeen.
it cannot. This product is strictly to control the fan speed. For the light you can use a different dimmer switch, just need to make sure you wire it properly.
