sheesh dunno where id start without it , double the amount of time to get the same results

once you have completed the scan the last step is align it to the co ordinate system , this is done by drawing a plane , a line and a point onto the scan. using these references the scan will change orientation to align to XYZ in solidworks

@@carbonmk1are you importing as graphics body?

@@xxBOOSTYxx i import as an OBJ , as you can convert to mesh and work on it then.

@@carbonmk1 thanks for the info. Not long got the einstar and haven’t a chance to stuff around much. Downloaded a few scans online which all sent to make solidworks very laggy.

@@xxBOOSTYxx yes make sure you take visible lines off on the display , makes a massive difference

im down in Jbay , next to port elizabeth

Nice work bud. I'm looking forward to the upcoming videos.

;)

You going to shoot some yt video ?

Going to redo it with a few special tweaks