Hello friend, i have a motherboard a MSI that has a winbond W25Q128JV bios chip, due to a bad flash now is inoperative, i have the ulink nt, can i use it to reprogram this bios?
@@usbbdm i got the chip detected, but it seems that the dump process gives me errors cause i think maybe because of the xml target is something generic, but im not very sure how to input the proper data so the dump can be OK in the verify process
fun fact, the t42 does have a can resistor, just not on its 2 sets of CAN bus pins. It exists on pins 15 and 19 and on applications it was used, there were jumper wires in the harness to the main bus pins.
Id love to learn how to implement software to hardware like this. I have some hardware I want to hack with jtag to clone a chip for an attempt to repair it. I have to replace a BGA chip but want to pull the data off before replacement since part of the chip has failed. I got a datasheet of the BGA but unsure what software to use to get the data off the chip properly.
Mine when I read it is blank, on both cflash and dflash. tried connecting the vcc to pin1 or connecting to table. Is it right to write other dflash or cflash from other camera some model?
Hi, how are you? I want to ask you a question I have been watching your videos for a long time looking for the solution to the e38 GM ecu that remains in a programming and cannot be recovered in this case if it was in a GM P12 programming process just like the E67 but cylinders with your software I can recover it since it does not communicate thanks
Sweet! I find it helpful to use something like vs code to search and remove repeated messages, I continue till all I have are unique messages that makes it easier to decode it. Then sort by module address. If we can create a parser to do that it would be very help for both j1850 vpw and iso-can.
This u-Link NT programmer is really easy to use. But I having trouble with flashing SPI NAND flash using RT809H programmer. When reading a MX35LF2G14AC NAND flash, many bytes are inconsistence and in writing mode as well. Do you have any suggestion to overcome with that saturation? Thank in advanced.
SPI NAND virtually uses just SPI protocol. If you are talking about RT809H programmer, I do not know. But keep slower clock speed might help. Also see if you need to pull up any pins like HOLD and WP.
Just checked it is possible to add this ECU support with a remote unit just takes a little bit longer than having it locally and might not have the boot mode or JTAG mode developped.
Hello, please excuse my ignorance because maybe my question is implied but, is this process of programming the same for cloning? As in can I grab the flash from a faulty ecu and program(flash) it to a good one using this method?
Im new to all this i was given 3 pcm that seem to be deep bricked what program are you using to do this and could I use the factory computer plug to do this
L.E. I pay for this item on 14.04.2024,it was shipped on 15.04.2024 and i receive the package on 30.04.2024,in Romania,in perfect conditions. Very very fast shipping from Canada to Romania! Awesome! Brilliant seller! Many thanks! Instant activation of product, after i sent email for this! I will try to use it for programming an volvo CEM,1999,2.0T and come back with review! Goog luck, everyone!
Hello, excellent explanation, I have some e39 and e39a that were blocked when writing them with I/O terminal, it has been impossible for me to unlock them because I do not have the shadow flash, could this interface do something
Hello. I buy this item and pay with paypal. I receive confirmation of purchase on my email adress and after two days,i receive another email with shipping confirmation,without any information of package number, tracking number,document number,anything.! Nothing. I send you two emails and i ask for any information to can find a information of shipping/delivery status but ,no response. Weird! How can i find a information? Many,thanks.
