I now have over 200 printing hours on this setup and haven‘t had any issues with that. Maybe because I‘m not actively heating the chamber. With the bed at 100C the enclosure gets up to around 35C with an ambient temp of around 20C. So no Problem with overheating the electronics
Wife: honey when are you going to come in for dinner? Dude: soon as I’ve finished building and testing my fire extinguisher cannon I’m making for RU-vid….. wife: I think we need to have a talk
I've never seen a fire extinguisher with that large of an opening. Replace that silly little valve with a two inch ball valve and use a pneumatic actuator to open it and you will be blowing holes through car doors.
@@Mika_357 The Weaponeer is a more useful book, by the same guy, Kurt Saxon. Now days, having it will probably get you put on a list. 40yrs ago, it was a cool book of improvised devices. Anyway, stay safe!
I usually pump it up with my shop compressor which goes to about 9 bars. I only use the bicycle pump for pressurizing it to 13 bars afterwards, but even that sure is a good workout ;D. Whether a golfball will fit depends on the barrel you're using. But with the pipe I used it actually fits!
@@Mika_357 Thanks for the quick reply. I'm building one of these out of a small oxygen tank from a cutting torch. It should handle 200psi with no problem, if yours held 190. Thanks again!
Super , danke für das Video 😊👍 die alte Kette hast du einfach geflext oder wie kann ich diese am einfachsten entfernen? Danke im voraus für die Antwort!
