Kulzer - Your lifetime partner for trusted and innovative dental solutions.
As one of the world’s leading dental companies and part of the Mitsui Chemicals Group, Kulzer has been a reliable lifetime partner for all dental professionals for about 90 years. Whether analogue or digital dentistry, aesthetic or tooth preservation, prosthetics or periodontology - as a polymer specialist and digital solution provider, Kulzer stands for trusted and innovative dental solutions. This is us. This is Kulzer.
Thank you for your interest in our product. For more information on the firing temperature, please refer to the product information brochure. www.kulzer.com/media/product-downloads/international-en-int2/heraceram/heraceram-zirkonia-750/heraceram-zirkonia-750-productinformation-ii-en-12-23.pdf
This is not logical, can you explain again? If cte of metal is higher, it will shrink more during cooling and ceramic will not go along. there will be gap between materials and scenario that you describes as 2. I think 2. and 3. scenario should be reversed. Please help! Thanks
Remember, a bond forms between the ceramic and the oxide layer formed on the metal alloy interface. Also, remember that while the CTE of the metal is higher than the ceramic, it is only a small difference. The "pulling force" is enough to compress the ceramic and reinforce it, but not enough to overcome the bond strength of the ceramic and the metal.
Hello. I have seen the video from the course in India and i want to ask. Can i apply the pre opaque after i used the primer for bonding or not ? Or i can use pre-opaque only, before the opaque ? Thank you.
Thank you for your interest in our products. For the red HeraCeram ceramic you can use the NP-Primer OR the Pre-Opaque as a bonder, do not apply both. The HeraCeram Saphir ceramic should only be used with the NP-Primer. Have a look at the FAQs: www.kulzer.com/en/en/for-dental-technicians/products-by-indication/ceramics/heraceram-faqs.html
Thank you for your interest in our products. Please visit our website and select your country to find out the local contact information. www.kulzer.com/en/en/start/worldwide/worldmap.html
Thank you for your interest. The recommended mixing ratio is 23g powder to 50ml water. For more detailed instructions, please refer to the Instructions for use.
Thank you for your message. You should treat the oxygen inhibition layer by covering the restoration with a layer of Kulzer Insolating Gel and a 90 second program at the end of your layering.
Thank you for your interest in our products. For Saudi Arabia, please contact our office in Dubai: www.kulzer.com/int2/en/start/middle-east/middle-east-startpage.html
Den Modellguss bei Freiendsituationen dorsal nicht nach bukkal verschließen, sondern nach oral öffnen. Somit hat man am Tuber einen größeren Kunststoffsattel, welcher unterfütterbar ist und die Prothese ist besser abgestützt. #schneeschuhprinzip
7th generation adhesives are self-etch adhesives whereas 8th generation adhesives, also known as universal adhesives, offer more advantages: Universal adhesives can be used in self-etch, selective enamel etch or etch&rinse mode according to the needs of the individual situation or personal preferences. Kulzer's iBOND Universal bonds to all dental materials.
Is a soaking in alcohol or ethyl acetate needed for getting rid of any fat residue? Is oxidation firing needed before coating with NP Primer? Thanks for your help.