@3Dreloading I tried 5 3" cheddite hulls, and they look horrible. Did exactly what the video showed. I even tried doing it slowly and the same results. I just ordered a mec reloader it won't do me wrong. I'm not saying the product is bad it doesn't work for me
i would like to but youtube dont like the showing of load data , companies like Hogden and Alliant all have free load data on thier sites you can get it there
So these instructions aren't really instructions. We have to stumble through and figure out what piece does what by meticulously rewinding and carefully watching.
Pretty slick set of tools for expanding the capabilities of the Lee Loadall, it must have been a fun puzzle to solve getting the parameters just right!
Cannot locate your email, I am interested in purchasing a special 12 Guage Unit to trim dowm 2-3/4" Hulls to Mini Shells. Please provide your email address.
thanks for asking about the trimmers, i sell a range of them on ebay under the name "3dreloadingandmore", i do a mini version for cutting down shotshells to make mini shells it will cut shells down to 1,5" in length. here is my email address aberisle@gmail.com
I just got your kit and have watched the video a few times…starting to sink in. Also, I am having difficulty locating the Mec 410 resizer. Can you help? Thanks
Where abouts are you?.. in the UK you can get them from Clay Game or Reloading UK, in the US Ballistic products or direct from MEC and there are loads of suppliers in Ebay wher you can buy one from
@@3Dreloading I've noticed a couple problems. It seems like the shot is jamming up and when I crimp new hulls the crimp looks great. Then after a few minutes it starts to undo. I'm using an ounce and a half.
if the shot is jamming in the drop tube just keep a screwdiver handy and give the droptube a couple of taps when dropping the shot and this should free the shot to drop properly, if the shells are opening up after crimping you could have too much shot in try reducing the load down by removing a few bits of shot and see if that helps or get a dime and put that ontop of the crimped shall and try doing the finish crimp again and this should push the crimp a bit deeper. i think it is most likly to bee too much shot though.
Yes they are for sale the price is $32 that includes postage, you can get them from me on ebay just look for 410 loading tools for the lee loadall and you will see them or try my ebay ID "3Dreloadingandmore"
Thanks for asking about the tools i sell them on ebay under the name 3dreloadingandmore they are both instock at the moment here is a link to the 410 tools, if youtube will allow it: www.ebay.com/itm/204556939902
Thanks for asking about the tools, i sell them on ebay just search for "410 loading tools for the lee loadall" and you will see them, they are instock and ready to ship in a day....thanks...james
I sell them on my ebay shop here is a link to them www.ebay.co.uk/itm/204479401116 or just look on ebay for "3dreloadingand more" and you will find them there