Medyo nakaangat yung screen nung akin pagbalik ko. Siguro inangat ko ulit siya nung nakalimutan ko ibalik yung itim na takip para sa LCD yung glue kumapal.
In this case he should had a setting of L1 for a battery cell series = "4 count" {1 lithium battery series count is - 4 single cells count as 1 unit add}
I was having an idea that smd rework station has an adjusting knob for fan and temp control It delivers voltage upto 24 v Why can't we use it to make variable bench power supply If you can make one It is a totally different project no one has ever done
Dear good sir. Thanks for the video, it's really nice. I ordered the exact same parts as shown in the video but i have one question: is the extra fuse necessary? If yes, are 10A enough? Or should i rather use 16A (I'm from Germany and we have 230V and up to 16A from the wall). I think there is a fuse on the dc2412, but not sure. Thanks!
Please what is the brand of the spot weld machine that you tested?. Any comments on it as I'm looking to purchase a reliable machine? Any recommendations? Thank you
I didn't know it requires to be set up until after I installed it. Anyway, I skipped the setup bit (cos maybe the meter and the BMS communicated somehow) 100% @54.6vdc Full Bar....which is normal, so far....:) (i'll show concern if none of these figure change during the course of discharge) Shall run it for a while on same charge and see if anything looks "not quite right". Did the ol' paper and pen bit prior to getting this nifty gauge, and it will be helpful determining the accuracy. Voltage Check on Multimeter = 54.6vdc Voltage Check on Voltage Unit = 54.3vdc (i'm not going to whine about .3 diff) anyway, one of them MUST be correct!. 😂 The reason I am writing this is because the dude make this video showed 4 cells, which is cool, but the problem I realised from then on was I do NOT now how many individual cells there are in my 48V/20AH pack... Comments +/_ welcome... 🤔🤭🤫 Mick
I used transformer 9 0 9 5408 diode in my xl4015 module. Now it shows 23 volts but after loading it becomes 9 volts, why is this happening? And what to do.
Hello i have acer aspire 5 (A515 - 54G) and i wanted to upgrade my RAM. Currently i have 2 x 4GB ( 2400MHz) and i wanted to replace one of this slot with 16GB. Do i have to replace with 16GB (2400MHz) or i can put (2667 or 3200MHz). Thanks in advance for the answer.