22 volts per 3 mm thickness is too much, responsible seams without a gap, on MIGMAG do not weld from top to bottom, in the corners finishing the weld is not the right solution, the tightness and integrity of the seams is doubtful
magandang araw po sir , isa po aku sa mga subscriber nyo po ganda po ng mga content nyu subra po akung natoto bilang isang aspiring welder din, tanong lang po sana sir kung ok lang po ?medyo d ku po kasi kabisado parte po sa pag pili ng voltage at tsaka speed po ? baka maka gawa po kayo ng content na tips ano ang magandang setting ng voltage tsaka speed po para po sa ibat ibang klase kapal ng bakal po maraming salamat po sir Godbless po☺️
boss idol good day? maraming salamat. marami akong natutunan sayo. ask ko lang idol, SMAW WELDER kasi aq. may balak kasi mag training pa aq ng isang level. anong maganda idol GMAW or FCAW?
Why didn't they put the single bevel on the side with the butt joint instead? Makes it alot easier to weld without the weld drooping down everywhere. That's what they do at my workplace on those sorta welds. We also weld structural steelwork
Worked a heavy fab shop for a few years we werent allowed to preheat even in the wintertime.Machines were preset not to go under a certain temp.Place was a dungeon in the summertime.
